User manual LAWN MASTER 53603

[. . . ] Model 53603 Owner's Manual Español - P. Erase Program Information Sensor Override . Introduction: What is a Watering Cycle? Each watering cycle opens and closes all the valves assigned to a program, in sequence, starting with the lowest valve number. For example, in the sample watering plan shown, program A has three start times which initiate three watering cycles. [. . . ] If a program has all three start times turned off, then that program is Off. (All other program details are retained). Because there are no start times, there will be no watering with that program. This is a convenient way to stop one program without turning the dial to the OFF position in case you need the other program(s) to water. Selecting Days to Water This sets the days of the week you wish to water. There are four different options: odd days, even days, skip days, or specific days of the week. 7 Selecting Odd or Even Days This option will water only odd days or even days of the month. Press the + button to select or the ­ button to cancel Odd Days. Press the Next button to go to Even Days. Press the + button to select or the ­ button to cancel Even Days. Note: The 31st of any month and the 29th of February of a leap year, are always treated as Off days in Odd Days watering. Selecting Skip Days This option allows you to select an interval from 1 to 30 days between watering days. Press the Next button to go to Skip Days. Press the + or ­ button to select the number of days to skip before each watering day. Selecting Specific Days of the Week This option allows you to water on specific days of the week, e. g. Press the Next button to advance to the day of the week option. Press the + button to activate specific days ON, then use the Next button to sequence through the individual days. Press the + button to turn on a particular day of the week to water. Press the ­ button to turn watering off that day. Press the Next button to advance to the next day of the week. Repeat steps 9 and 10 until all desired days have been selected. Return dial to Run position. 8 Run Set the dial to the Run position to enable automatic watering of all programmed schedules. Off Use this dial position to turn off watering, such as when it is raining or you don't want watering. As long as the dial is in the Off position, watering programs will not be activated automatically. This position is also used to terminate any running programs whether manual or automatic (allow 3 seconds to turn off). For immediate shut down, turn to Off and push the ­ button. [. . . ] If your sensor is enabled, make sure you have a sensor hooked up. Clear this display by turning the dial. 16 The Toro Promise - Limited One-Year Warranty The Toro Company and its affiliate, Toro Warranty Company, pursuant to an agreement between them, jointly warrants, to the owner, against defects in material and workmanship for a period of one year from the date of purchase. Neither The Toro Company nor Toro Warranty Company is liable for failure of products not manufactured by it even though such products may be sold or used in conjunction with Toro products. During such warranty period, we will repair or replace, at our option, any part found to be defective. [. . . ]