User manual LAZERBUILT FULL-DUPLEX CONFERENCE PHONE

[. . . ] Do not disassemble the product but refer to qualified service personnel in the following eventualities. If liquid has been spilt onto the product If the power cord becomes damaged or frayed. If the product does not operate normally by following the instructions contained in this user guide. If the product has been dropped or the case has been damaged. Important note This product has been designed for operation in conjunction with a mains electricity supply. [. . . ] You may wish to choose a location that is free from background noise. Your results may vary depending on the acoustics of the room and the number of people speaking. Installation Setting the Pulse / Tone switch. Before you can dial a call on the Summit conference phone, you must select which form of dialling it will use. All domestic telephone lines in the U. K. This is both fast and accurate and should be selected if possible. When connected as an extension of an office telephone system (PABX), the setting of this switch will be dependant on the telephone system in question. If in doubt, please contact your system supplier or following the procedure below. 1 Set the switch to the Tone position 2 Turn the unit ON (ON/OFF button) and listen for dial tone. 3 Dial a known number (remember to include any line access digit required by the PABX usually 9). 4 If the call is successful (ringing or engaged tone) the switch may be left in the Tone position. If the call is unsuccessful, terminate the call by pressing the ON/OFF button. Set the switch to the Pulse position and try the test above again. Using the Tone Button If you have set the Tone / Pulse switch to the Pulse position, you may temporarily change to Tone dialling by pressing the Tone button. This may be required when accessing automated telephone services, which require Tone signals. Setting the Ringer Volume Your Summit conference phone will ring for incoming calls. The Ringer Volume Switch may be used to adjust the volume of the ringer between High, LOW or OFF. With the switch set to the OFF position, the unit will not ring for incoming calls but can still be used to make outgoing calls, or to answer incoming calls ringing on a parallel extension phone Operation Making a Call Using the Summit Conference Phone 1 Press the ON/OFF button and listen for dial tone. 2 Dial the required number on the keypad (when connected to an extension of a PABX, remember to include any line access digit required). 3 When the other party answers, you may conduct a conversation using the built-in microphone. 4 When you have finished the call, press the ON/OFF button again. to include a non active party in your call i. e. you would like another partly to listen in to a conversation or discussion you are having, but not be able to take part in it. Mute The Summits microphone(s) may be turned off, by pressing the Mute button. This will still allow you to hear the other party but they will not be able to hear you. Press the Mute button again to return to normal conversation. Note : If you have installed the optional extension microphone, this will also be muted. Receive Volume You may adjust the volume of receive speech, by pressing the UP and DOWN buttons. [. . . ] Complies with the European RTTE directive Complies with the European EMC directive 89/336/EEC. If it becomes faulty within the guarantee period but after the first month, it should be returned for repair to Lazerbuilt (at the address shown above), either directly or via your retailer. After the guarantee period, return your product to Lazerbuilt, indicating the problems you are experiencing. Include your name, address, telephone number and a postal order/cheque for £5. 00 to cover the handling charge. [. . . ]