User manual LEGRAND 843 27

[. . . ] Note: Assemble "Upright Assemblies" as shown with channels toward inside. Slide Ball Holders (#35) into groove in top of Shroud (#17). See Figure 1. 2. Figure 1 3. Locate two Struts (#20) and insert a Round Top Tube Plug (#2) in the end opposite the larger hole. See Figure 2 Locate one Right Linkage (#21) (with three holes) and one Left Linkage (#22) (with two holes) and insert a Round Top Tube Plug (#2) in each end. [. . . ] With one adult holding the "Top Assembly" upright, swing Struts (#20) up and attach them to mounting brackets on bottom of "Top Assembly" using one screw (#27), Spacer (#26) and lock nut (#6) for each Strut. Tighten bolts tight but, do not over tighten. Swing Left Linkage (#22) up and attach it to Leg (#1) using one screw (#11), one Spacer (#44) and one lock nut (#6). Tighten bolts tight but, do not over tighten. Swing Right Linkage (#21) up and attach it to lower hole in Leg (#1) using one screw (#11), one Spacer (#44) and one lock nut (#6). Tighten bolts tight but, do not over tighten. See Figure 7, Detail D. Figure 6 Figure 7 4 16. Attach Safety Latch (#31) to outside of Leg (#1) on the right side of table using one screw (#28), one step spacer (#29), one spacer (#30) and one lock nut (#6). Note: Safety Latch (#31) should hang behind Right Linkage (#21) once attached. Tighten bolt tight but, do not over tighten. Attach bottom of Safety Latch (#31) to inside of Right Linkage (#21) using one screw (#27), one spacer (#30) and one lock nut (#6). Pull outward and lower the table half until legs touch the floor. Repeat steps 1 and 2 for other table half. Figure 13 PLAYING POSITION Figure 11 6 CARE AND MAINTENANCE You have purchased a quality product that will give you years of enjoyment. By following these simple maintenance steps, you will add to the life of your new table. The top (playing surface) of your table is made of particle board. Like all products made of wood, it can be affected by atmospheric changes in both temperature and humidity. This may cause a slight sag or distortion as the top expands or contracts. This is normal and should not cause concern as it does not detract from the play or utility value of the table. After assembly of the table, you can minimize the effects of temperature and humidity changes by storing the table in the folded up position in a dry area when table is not in use. STORAGE OF YOUR TABLE This table must be stored indoors to prevent damage to the playing surface. Dampness and extreme temperature changes can cause the wood to warp, swell, crack or blister. When your table is not in use, it should be folded up in a dry area. [. . . ] WARRANTY COVERAGE: LEGRANDS warrants to the original Consumer Purchaser that any Product of its manufacture is free from defects in material and workmanship when used for the intended purpose under normal use and conditions. THIS WARRANTY IS VOID IF THE PRODUCT HAS BEEN DAMAGED BY ACCIDENT, UNREASONABLE USE, NEGLIGENCE, IMPROPER SERVICE, FAILURE TO FOLLOW INSTRUCTIONS PROVIDED WITH THE PRODUCT OR OTHER CAUSES NOT ARISING OUT OF DEFECTS IN MATERIAL AND WORKMANSHIP . WARRANTY PERFORMANCE: During the above one (1) year warranty period, LEGRANDS shall repair or replace with a comparable model, and/or Product, or component thereof, for any product which may prove defective under normal use and proper care, and which our examination shall disclose to our satisfaction to be thus defective, please contact our Warranty Dept. 1-866-873-3528 / Warranty Dept. Or Write us at: Escalade® Sports, Inc. [. . . ]