User manual LEHEL A803KA

[. . . ] SIBIR TYP: 803 K Gebrauchsanweisung Mode demploi Instruzioni per luso Operating instructions Gebruiksaanwijzing Seite 4 DE FR AT BE CH IE CH CH LU LU Page 12 Pagina 19 IT GB NL ES Page 26 Pagina 35 Instrucciones de manejo Página 42 207. 4887. 01 0402 Fig 1 2 3 GB Dear customer, please read the instruction book and all additional information before using the appliance. It is most important that they should be retained with the appliance for future reference! 1. Warnings and directions These warnings are provided in the interest of safety. You must read them carefully before installing or using the appliance! [. . . ] WARNING - THIS APPLIANCE MUST BE EARTHED!1363) fused-plug is used, it should be fitted with a 3 amp fuse. In other cases, the circuit to which the refrigerator is connected should be fitted with a 5 amp fuse. 1) - 3-way-switch (D) should be in position 230V. 28 GB Turn thermostat knob (A) clockwise to position 6/MAX. Only after approximately 1 hour will the unit become noticably cool (frost on evaporator). - The temperature can be regulated using the thermostat knob: '0'=off, 1-6 increasing degrees of coolness. - After sufficient cooling (approximately 5 hours), the thermostat position can be set to a lower temperature, between 2-5. The thermostat will now automatically regulate the set temperature. 1) - 3-way-switch (D) should be in position '0'. - Turn thermostat knob (A) anticlockwise to position '0' (a slight resistance will be felt just before this position). D/C operation Do not use any additional form of energy (mains/gas). A safety fuse must be installed in the electricity supply between battery and refrigerator in a duct. 12 V: maximum 15 amps; 24 V: maximum 7. 5 amps. max. cable lengths Cable cross section 2. 5 mm2 4. 0 mm2 6. 0 mm2 12 V until until until 2. 5 m 4. 0 m 6. 0 m 24 V 5m 8m 12 m It is not necessary to consider the polarity when connecting the unit. Check that the battery voltage and line voltage data correspond to the type-plate on the back of the unit. If no batteries are used independently of the vehicle, the mobile cooler should not be operational when the vehicle is in motion, since the battery can discharge to the extent that the vehicle engine cannot restart when the vehicle is at a standstill. During transport, the door safety button (G) must remain depressed, so that the door is kept in a closed and safe position. Recommendation: before journey, pre-cool the unit using A/C operation. To turn on Plug the car plug must be mounted according to your car on the connecting cable into the plug connector/cigarette lighter. 29 GB When using battery operation, the cooling performance is not thermostatically regulated, i. e. When knob (A) is ineffective or if the temperature is unnecessarily too low: Turn off unit Pull out plug from socket. 8. Liquid gas operation Do not use any additional form of energy (mains/battery). The unit must not be connected to town or natural gas pipelines. [. . . ] Close gas cylinder or pressure regulating valve. Turn knob (B) clockwise to the off position*. *excluding units for the United Kingdom. (Fig. After-sales service Should a problem arise with the unit, please check the following before contacting customer service: - is the unit suitably placed and is it well ventilated? [. . . ]