User manual LEICA CRF 1200

[. . . ] Further information about the subject is available at your community administration, your local waste collection company, or in the store where you purchased this equipment. Disposal of electric and electronic equipment (Applicable in the EU and other European countries with separate collection systems) Then, thread the longer loop through the smaller loop and pull it tight so that the carrying cord is securely attached to the eyelet. Inserting and changing the battery The Leica Rangemaster CRF is supplied with power by one 3 Volt lithium cell (e. [. . . ] Scan mode is particularly practical when measuring to smaller and moving targets. Note: Due to the constant measurements, the power consumption is greater in scan mode than for single measurements. Distance measurement To measure the distance to an object, it must be perfectly targeted. To do this, activate the target mark by pressing the release button (3) once. The target mark remains lit for about 4 seconds after letting the release button go. If the button is kept pressed, the target mark remains lit. While the target mark is lit, aim the Leica Rangemaster CRF at the object and press the release button a second time; the distance is then measured and displayed. The target mark disappears briefly during the measurement. A new measurement can be made at any time, as long as the target mark is lit, by pressing the release button The maximum range is achieved with a well reflecting object and unaided visibility of 10km/6. Range Color of object Angle of object Size of object Sunlight Atmospheric conditions Shape of object longer white perpendicular larger than measuring beam weak (cloudy) clear uniform (house wall) shorter black acute smaller than measuring beam strong (midday sun) hazy irregular (bush, tree) Maintenance/cleaning Your Leica Rangemaster CRF does not require special care. Any large dirt particles, such as sand, should be removed with a soft brush or be blown off. On the lens or eyepiece can be can be cleaned off the lenses by first moistening them with a damp cloth and then wiping with a soft, clean chamois leather or lint-free cloth. Important: Do not exert excessive pressure when wiping heavily soiled lens surfaces. Although the coating is highly resistant to abrasion, sand or salt crystals can still damage it. The housing should be cleaned only with a damp leather. Using dry cloths can lead to an electrostatic build-up. Alcohol and other chemical solvents must not be used to clean the optics or the housing. As well as its type designation, each Leica Rangemaster CRF has its "personal" serial number. [. . . ] This equipment generates, uses, and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the 23 Equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures: · Connect the equipment into an outlet on a circuit different from that to which the receiver is connected. [. . . ]