User manual LEICA IP S

[. . . ] Leica IP S Automated printing system for microscope slides Operating Instructions Leica IP S V1. 6 English - 07/2005 Always keep this manual together with the instrument. Read this instruction manual carefully before working with the instrument. NOTE The information, numerical data, notes and value judgments contained in this manual represent the current state of scientific knowledge and stateof-the-art technology as we understand it following thorough investigation in this field. We are under no obligation to update the present manual according to the latest technical developments, nor to provide our customers with additional copies, updates etc. For erroneous statements, drawings, technical illustrations etc. [. . . ] If the message shown left is displayed, the driver has already been installed on your PC on a previous occasion (e. g. In this case, be sure to select REPLACE EXISTING DRIVER. In the PRINTER DEVICE NAME box, you can insert any printer name you wish - the printer name you insert will subsequently be displayed in the printer folder and in the PRINT menu of all Windows applications. To avoid erroneous printouts, select NO when asked whether you want to use this printer as the default printer. Two more on-screen prompts will be displayed: · When prompted whether you wish to share the printer in a network, select --> NOT SHARED, if the printer is used on a local host. · When prompted whether you would like to print a test page, select --> NO. Click FINISH to complete the installation of the printer driver. The printer name selected in step 8 (see above) will displayed in the printer folder and in all print menus. When installing under Windows 2000 or Windows XP, at this point the message "DIGITAL SIGNATURE NOT FOUND" will be displayed. This message is displayed simply to inform you that the printer driver has not yet been certified by Microsoft. BE SURE to click YES to continue installing. 11. Finish installation by restarting your computer. 30 Instruction manual V 1. 6 ­ 07/2005 4. Open the printer folder: START --> SETTINGS --> PRINTERS 2. Right-click on the icon of the newly installed printer, a quick menu opens up. The PROPERTIES dialog box contains several tabs - select the PORTS tab. IMPORTANT!Windows 2000 does not contain the PORTS page. Fig. The port selected during installation (COM 2 in the example here) must be highlighted. Tick the check box ENABLE BIDIRECTIONAL SUPPORT. Click on CONFIGURE PORT to open the PORTS dialog box. Select the corresponding port and click on SETTINGS. Leave all other settings as shown in Fig. 25. Leica IP S 31 5. Operation The control panel · consists of a membrane keyboard with six pressure-sensitive keys (four of them with an LED), two LED displays and a two-figure seven-segment display. · controls the printer functions and the print jobs that are defined via the control software. [. . . ] When code 13 is issued, the bulb has to be changed. For details on how to insert / replace the flash tube, please refer to chapter 4. 6, page 22. 10 sec. Before replacing the flash bulb, switch off the printer and unplug the instrument from mains. After changing the bulb, switch the printer back on. Then go to Off-line mode and press and hold the ERROR button for 10 seconds - code 13 disappears from the display. 7. 4 Power failure · Check whether there is a general power failure (no mains power). · Check whether the mains plug is inserted correctly into the wall outlet and whether the wall outlet is switched on, if applicable. [. . . ]