User manual LEICA LP C SOFTWARE INSTALLATION MANUAL REV 2

[. . . ] LabeLase® Producer Software installation manual for Cassette Printer Revision 2 30. March 2010 Always keep this manual with the instrument. Read carefully before working with the instrument. Table of Contents Copyright © 2007 InfoSight Corporation All rights reserved InfoSight ® is a registered trademark of InfoSight Corporation LabeLase ® is a registered trademark of InfoSight Corporation InfoSight Corporation 20700 US HWY 23 Chillicothe, Ohio 45601 USA Telephone: 001-740-642-3600 website: http://www. infosight. com eMail: service@infosight. com LabeLase® Producer - Installation 3 Table of Contents LabeLase® Producer Software Installation Manual for Leica LP C ­ Cassette Printer 1. Software/firmware licensing agreement . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . [. . . ] Rotate - Rotate the selected field or fields by 90 degrees in the clockwise direction. If more than one field is selected, they will be rotated as a group. Any fields that are rotated can be restored using the Undo feature. Align - Provides a list of alignment tools. Alignment tools are only accessible if more than one field is selected. The align menu provides tools for aligning multiple fields in various configurations. Left - Align all fields to the leftmost edge. Right - Align all fields to the rightmost edge. Top - Align all fields to the topmost edge. Bottom - Align all fields to the bottommost edge. Middle - Align all fields to the vertical middle of the objects. Fields will be centered along an imaginary horizontal line. Center - Align all fields to the horizontal middle of the objects. Fields will be centered along an imaginary vertical line. Note that the terms top, bottom, left and right refer to the fields themselves, not the display screen. Fig. 42 Snap To Grid Enables or disables the "Snap To Grid" command. When enabled, all fields that are added or moved will have their coordinates adjusted to match the current grid setting. If this feature is enabled when one or more fields are selected, the selected fields will be snapped to the grid. LabeLase® Producer - Installation 117 3. User Interface View Menu The View menu allows you to control what you see on the designer form. Zoom Out - Reduces the size of the cassette image display so that more of the layout can be seen on the screen. Note that as you zoom out, detail is lost when the image is reduced in size. Zoom In - Increase the size of the cassette image display. This allows you to see more detail, at the expense of seeing less of the cassette image at one time. Anchors - Each field is anchored to the layout in the lower left corner of the field. [. . . ] Forward Button - This button will cause the motor to move in the Right direction by the number of steps specified in the Number of Steps drop down list. Number of Steps - This drop down list allows you to specify the number of steps to move when jogging in either the left or right direction. You can select any number of steps in the list, or type in a specific number of steps. Desired Motor Position - This entry field display the desired motor position, which is the distance to move past the home sensor. [. . . ]