User manual LEICA MOJORTK

[. . . ] Leica User Manual Version 1. 5 English Leica mojoRTK, Introduction 2 Introduction Purchase Congratulations on the purchase of a mojoRTK system. This manual contains important safety directions as well as instructions for setting up the product and operating it. Refer to "10 -2Safety Directions" for further information. Read carefully through the User Manual before you switch on the product. [. . . ] The mojoRTK console must receive at least 15 seconds of continuous reference corrections for the ten minute interval to reset. If the position drift upon signal restoration is greater than the Maximum Drift set, guidance will be disabled and an error screen will be displayed on the mojoRTK console. Unlock code to unlock the Glide feature on the mojoRTK base station and console. Service Pack 4 or later software Updated ME3 firmware (v3. 610 or later) Required items • • • Please contact Leica Geosystems or your local reseller for further details on activating this optional software module. Unlock codes Glide For information about installing the unlock codes refer to "B. 1 Unlock Codes". Under Glide the vehicle may drift left or right. Over time this drift may become significant. The default maximum drift limit is 0. 1m. The user has the option to set a maximum drift value for Glide. Navigate to Menu -> Settings -> Guidance -> Max. The maximum allowable value is 10. 00m. Guidance Implement Offset Backup Waylines Load Waylines Max. Drift S_mojoRTK_048 Max. Drift 0. 00m 0. 10 m 0. 10m S_mojoRTK_049 With the Glide feature enabled, Glide will automatically activate following the loss of signal from the base station. In a typical scenario the user would set up for the days work. A GPS fix would be obtained by the mojoRTK console and the base station. The base station icon would have at least one bar and the satellite icon would have at least one bar. GG S_mojoRTK_050 Leica mojoRTK, Normal System Operation 105 Leica mojoRTK, Normal System Operation If at some point the signal to the base station is lost, after 15 seconds the user is presented with the continue on Glide screen. Confirm 106 You are now running outside RTK accuracies, do you wish to continue on Glide?Yes S_mojoRTK_051 No Always Selecting No will disengage steering. Selecting Yes will allow steering to remain engaged. The next time Glide activates the confirmation screen will be displayed. • Selecting Always will allow steering to remain engaged. Glide will remain activated for a maximum of ten minutes. • • Glide GG S mojoRTK 052  • • If Always has been selected the prompt to activate Glide will not be shown unless the mojoRTK console has been restarted. If Yes or Always has been selected then Glide will remain activated for a maximum of ten minutes. [. . . ] Not all USB drives operate successfully with the mojoRTK products - please test and verify that the chosen USB drive operates as expected before using it. • • • USB Flash Drive / Memory Stick A computer running Microsoft WindowsTM (98, XP or later) Available USB port on the computer Limitations Required Items Leica mojoRTK, Additional mojoRTK Information 199 Leica mojoRTK, Additional mojoRTK Information Procedure The USB Flash Drive is inserted into the computer. A window may be displayed asking what action to perform on the USB stick. Select Open Folder to view files and click the OK button. 200 A window should then open showing the current contents of the USB Flash Drive. Left-click on the up icon on the toolbar to show a list of all drives in the computer. Right-click the drive icon for the USB stick to reveal the Format menu option. Leica mojoRTK, Additional mojoRTK Information 201 Leica mojoRTK, Additional mojoRTK Information Select FAT (File Allocation Table) from the File system box, then click Start. 202 A window will then be displayed asking you to confirm if you want to format the USB Flash drive. [. . . ]