User manual LEICA X8000 SAFETY DATA SHEET

[. . . ] Give oxygen or artificial respiration as needed. For even minor eye contact, immediately flush eyes with copious amounts of cool water for 20 minutes retracting eyelids often to ensure thorough washing. Wash skin thoroughly with mild soap and rinse with water for about 20 minutes. [. . . ] Do not flush into or allow to enter surface water, sanitary sewer or ground water system. sand, diatomaceous earth), collect and store in a suitable container for disposal according to local regulations. ENVIRONMENTAL PRECAUTIONS: METHODS FOR CLEANING UP: Section 7: Handling and Storage HANDLING: Use only in well-ventilated areas or wear suitable respiratory equipment. Wear protective equipment (see Section 8). Do not eat, drink or smoke at the workplace. Isolate from sources of heat, sparks and open flame. Avoid exposure to direct sunlight, UV radiation and strong oxidisers. Do not expose to temperatures exceeding 60ºC for long periods. Keep away from oxidizing materials, acids, bases. STORAGE: INCOMPATIBLE MATERIALS: Section 8: Exposure Controls/Personal Protection EXPOSURE LIMITS: ENGINEERING CONTROLS: PERSONAL PROTECTION: RESPIRATORY: HAND PROTECTION: Not tested Local exhaust ventilation recommended. Ensure adequate ventilation or wear suitable respiratory equipment. Do not use natural rubber or PVC gloves. Wear nitrile rubber gloves Replace gloves immediately when torn or any change in appearance (dimension, colour, flexibility etc) is noticed. Wear a face shield, chemical goggles or safety glasses. An eye wash facility and safety shower must be available nearby. EYE PROTECTION: SKIN: OTHER: The above information is believed to be correct but does not purport to be all -inclusive and shall only be used as a guide. shall not be held liable for any damage resulting from handling or from contact with the above product. XENNIA TECHNOLOGY LTD Date: 29th August 2006 Page 4 of 7 MATERIAL SAFETY DATA SHEET Section 9: Physical and Chemical properties APPEARANCE: ODOUR: ACIDITY (mg KOH/g): BOILING POINT: FLASH POINT: SPONTANEOUS IGNITION: VAPOR PRESSURE: EVAPORATION RATE: SPECIFIC GRAVITY: SOLUBILITY: IN WATER: IN ORGANIC SOLVENTS: VISCOSITY: Section 10: Stability and Reactivity CONDITIONS TO AVOID: Black liquid. Ether Not applicable 117-125°C (760 mm Hg) 30°C (closed cup) 290°C 1170 Pa 0. 75 BuAc=1 ~0. 9 No Soluble in polar solvents 7. 9 cP @ 25oC Avoid temperatures higher than 60°C. Avoid friction with temperature increase as a result. MATERIALS TO AVOID: Avoid free radical producing initiators. Avoid contact with strong oxidizing agents. [. . . ] This ink has not been tested for reproductive effects. The above information is believed to be correct but does not purport to be all -inclusive and shall only be used as a guide. shall not be held liable for any damage resulting from handling or from contact with the above product. XENNIA TECHNOLOGY LTD Date: 29th August 2006 Page 6 of 7 MATERIAL SAFETY DATA SHEET Section 12: Ecological Information ECOTOXICOLOGICAL INFORMATION: COMPONENT diphenyl(2, 4, 6trimethylbenzoyl)phosphine oxide No data available for this formulation. Acute toxicity: Fish: LC50, 48h: 1-10mg/l Daphnia: not tested Bacteria: EC50, 0. 5h: >1. 0mg/l Algae: not tested Fish: practically non-toxic 1-methoxy-2-propanol BIODEGRADABILITY: diphenyl(2, 4, 6trimethylbenzoyl)phosphine oxide 1-methoxy-2-propanol ECOTOXIC EFFECTS: Acute toxicity: Not really biodegradable Readily biodegradable Do not discharge into drains or the environment, dispose to an authorized waste collection point. Section 13: Disposal Considerations MEASURES FOR DISPOSAL: Controlled incineration in compliance with local legislation. DISPOSAL OF CONTAMINATED PACKAGING: Treated as per residual chemical. [. . . ]