User manual LENCO CR-2000

[. . . ] There are no user serviceable parts inside the unit . Refer all servicing to qualified personnel. CAUTION The lightening flash with arrowhead symbol within the triangle is a warning sign alerting the user of "dangerous voltage" inside the unit. The exclamation point within the triangle is a warning sign alerting the user of important instructions accompanying the product. WARNING To reduce the risk of fire or electric shock , do not expose this appliance to rain or moisture. [. . . ] IMPORTANT DO NOT THROW BATTERIES IN FIRE !THE APPARATUS SHALL NOT BE EXPOSED TO DRIPPING OR SPLASHING. ENSURE A MINIMUM DISTANCE OF 5 CM AROUND THE APPARATUS FOR SUFFICIENT VENTILATION. ENSURE THAT THE VENTILATION IS NOT IMPEDED By COVERING THE VENTILATION OPENINGS WITH ITEMS, SUCH AS NEWSPAPERS, TABLE-CLOTHS, CURTAINS, ETC. . DO NOT PLACE NAkED FLAME SOURCES, SUCH AS LIGHTED CANDLES ON THE APPARATUS. TAkE ATTENTION TO THE ENVIRONMENTAL ASPECTS OF BATTERy DISPOSAL. USE THE APPARATUS ONLy IN MODERATE CLIMATES (NOT IN TROPICAL CLIMATES). DO NOT EXPOSE THE APPARATUS TO DRIPPING OR SPLASHING. Hold the ALARM 2-SET/OFF button for 2 seconds and press HOUR > (+) or < HOUR (-) to set the ALARM 2 hour digit, hold the ALARM 2-SET/OFF and press MINUTE > (+) or < MINUTE (-) to set the ALARM 2 minute digit, the ALARM 2 will show on alarm display when ALARM 2-SET/OFF button is pressed. SETTING THE WAKE MODE Switch the ALARM 1-AUTO/BUZZER/OFF and or ALARM 2-AUTO/BUZZER/OFF to select the mode below: AUTO: will wake up by radio when the time reach BUZZER: will wake up by buzzer when the time reach OFF: no wake up The ALARM 1 standby indicator or ALARM 2 standby indicator on the real time display become on when select AUTO or BUZZER. SNOOZE FUNCTION When the radio or buzzer sounds, press the SNOOZE to temporarily stop for 9min until alarm reach, press ALARM 1-SET/OFF to terminate the ALARM 1, press ALARM 2-SET/OFF to terminate the ALARM 2. GB 2 TO USE THE SLEEP TIMER When the radio is power on, press SLEEP button to activate the sleep timer, sleep time will display 00-10-20-30-40-50-60-70-80-90 by each press, timer will start after SLEEP button release for 2sec, and the radio will auto shut off when timer reach, or press the RADIO button to turn off immediately. ANTENNA The FM radio has a flexible wire antenna on the back of the unit, uncoil the wire and extend to its full length for best reception. SPECIFICATIONS Power Source: AC : 230V ~ 50Hz DC : 3V backup (2 x "AAA") Frequency range: FM : 87. 5 - 108 MHz Power consumption: 3. 4 W Dimension: 195(L) x 152(D) x 68(H) mm Weight: 600 g Due to continuing improvement, the features and the design are subject to change without notice. Where to place the item : Today's furniture is coated with a wide variety of lacquers and synthetic-coatings that are treated with an extensive range of cleaning products. Therefore, the possibility that some of these substances contain components that react adversely to the rubber feet of the item and soften them, cannot be completely excluded. The rubber feet of the appliance can cause discoloring to furniture surfaces. [. . . ] Therefore, the possibility that some of these substances contain components that react adversely to the rubber feet of the item and soften them, cannot be completely excluded. The rubber feet of the appliance can cause discoloring to furniture surfaces. If necessary, place the appliance on a non-slide surface. [. . . ]