User manual LENCO IPD-4300

[. . . ] Water and Moisture The unit should not be used near water. For example: near a bathtub, washbowl, kitchen sink, laundry tub, swimming pool or in a set basement. Ventilation The unit should be situated so that its location or position does not interfere with its proper ventilation. For example, it should not be situated on a bed, sofa, rug or similar surface that may block the ventilation openings. [. . . ] iPod is not included + Description of Parts Main Unit Top view Front view 2 1 6 5 Installation AC power Connection Connect the AC power plug into AC main outlet. 3 4 Rear view 8 AUX Firmly plug into AC main outlet 7 Remote Control (1) The battery compartment is located at the back of the remote control. (2) An arrow is marked on the battery lid. Follow the direction of the arrow and slide the door to open it. (3) Follow the polarity marked on the compartment and install two pieces of type UM-4 (AAA) battery into it. 6 1. iPod docking station 2. iPod docking connector 3. - / + button ----- Adjust volume level up or down 4. Standby button and Standby indicator -----To turn the unit on and off ; When the unit is at standby mode, the standby LED is on. 5. Remote Control Infrared sensor 6. Pair of Speakers 7. Power On / Off switch ----- To switch the power on and off 8. AUX jack ---- Auxiliary audio signal input 9. AC Power cord 7 9 REMOTE CONTROL 1 Listening to iPod 2 OK 1. Infrared Transmitter 2. Standby button ---- To turn the unit on and off 4 3. iPod Menu button 4. iPod OK button 7 5. iPod Play / Pause button 6 6. iPod Backward / Forward button 7 7. VOL + / - button ----- Adjust volume 10 level up or down 8. iPod Menu Up / Down button 9. iPod Random button 10. Mute button ---- Mute the volume 11. Battery Compartment ---- Located at the back of the remote control This model adopts different iPod models. Following steps guide you listening to iPod music. 1. Select and insert the proper adaptor for your iPod model into the docking station first. Your iPod can now be inserted into the docking port by placing the conmnector on the bottom of the iPod onto connector in the docking bay. Caution : Please be careful when seating the iPod into the docking to avoid damaging the 30-pin connector on the iPod or in the docking system. 2. Switch the Power On/Off switch to on position , the front Standby LED indicator lights on. 3. Press the Standby button once to turn on the unit and the Standby LED indicator turns off. 4. Now most of the iPod controls can be implemented by the remote control unit. To select iPod menu, press the iPod menu button. To select item from the iPod menu , press the iPod Menu Up / Down button. To confirm item selection, press the OK button. [. . . ] Note : Once the stereo plug is inserted into the AUX jack, the unit will switch to auxiliary input mode automatically. 3. Turn on the external auxiliary audio device. 4. The volume can now be controlled through the unit. Operate all other functions on the external device as usual. [. . . ]