User manual LENCO M-7001

[. . . ] Before fix the display, you can rotate the display left or right to adjust it at a proper angle to view. You can also turn the display upward or downward to find a good viewing angle, then rotate the knob (4) to fix the trestle (5). [. . . ] Press the switch under the headrest of the car seat and pull out the headrest. Assemble the Screen Mounting Bracket (2) to Screen Mounting Bracket (1) and Rotate combined bracket, then place them on the poles of the removed headrest to select proper hold position to install the base. Remove the Bracket from headrest and loosen the two screws by using the screwdriver, then place the two plastic tubes (3) on the holes that you just selected, then adjust them to proper position as shown in diagram below. Install the base on the poles of the headrest and adjust to proper position, then use four screws (ø3x10 (4) to fix the base 1 and base 2. (4) Screw (2) (1) 5. Install the headrest with the base and rotate the Mounting Bracket to the car seat in proper position, then use the screwdriver to fasten the two screws to fix the base. GB-6 INSTALL THE SCREEN ON THE BRACKET Insert the position plate on the screen unit into the clip screw plate and screw on the clip screw to fix the screen unit to the Mounting Bracket. Position plate (5) Position Clip-screw Rotate Bracket (6) Clip screw ADJUST THE ANGLE OF THE DISPLAY 1. Loose the clip screw on the side of the rotate bracket, then adjust the Mounting Bracket to the angle of the display to your need and screw on the clip screw to fix the Mounting Bracket. Clip screw 2. In order to adjust swing arm, you must first loosen as indicated by diagram with appropriate screwdriver. Adjusted by force will damage the Screen Mounting Bracket. GB-7 ELECTRICAL CONNECTION (1) (2) (3) YELLOW PVC CABLE (BLACK) (4) WHITE (5) RED (7) RED (6) BLACK (8) BLACK CAUTION: 1. Put the 9-pin mini din plug (1) into the 9-pin mini din socket (2) on the back of the display. The yellow socket (3) is connected to the VIDEO socket. The white socket (4) is connected to the AUDIO Out-Left socket and the red socket (5) is connected to the AUDIO Out-Right socket. When you want to use the unit, please cut the (7) and (8) two wires from the DC plug (6). [. . . ] EARPHONE VOLUME CONTROL KNOB Slide the knob (11) to change the volume of the earphone. REMOTE When connect DVD unit or another unit to the monitor through the jack (12), you can control the DVD unit or another unit by pointing the remote control handset directly to the remote sensor (3). [. . . ]