User manual LENCO PDR-19

[. . . ] Model: PDR-03 Instruction Manual (Portable Radio with DAB+) Bedienungsanleitung (Tragbares Radio mit DAB+) Manual de instrucciones (Radio portátil con DAB+) Handleiding (Draagbare radio met DAB+) Manuel d'instruction (Radio portable avec DAB+) Downloaded from www. Safety Information This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communication. However, this is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or or other reception, which can be determined by turning the equipment off on, the user is encouraged to try to correct the interference by one of the following measures: - Reorient or relocate the receiving antenna. [. . . ] Recall a stored station Once you have saved the stations to the preset buttons, you can recall by pressing the PRESET button. Then press or to select the stored stations, and press ENTER to confirm. Com manuals search engine Manual set Time Press and hold the INFO/MENU button to find the <Main menu> and press ENTER, press / and press ENTER to enter the <Time setup>. Then press ENTER button to enter the selection interface. Press / button to select the digits of the time and date. Set clock> Press ENTER> 00:00(Hour:Minutes)> Press / to select the Hour digits> Press ENTER> Press / to select the Minute digits> Press ENTER to confirm. Set date> Enter the date 01-01-2014 (Day-Month-Year)> Use the above steps of SET CLOCK to select the digits, press ENTER to confirm. *If selected NO UPDATE, the time and date will not update from the system, and you should manually set the time and date. *If selected FROM RADIO, the time and date will auto update from the system if it detects the RDS signal. But if the RDS signal is not strong enough, the time/date will not update. After finish the steps above, the time is set up manually. When the <Alarm 1: off> appears, press ENTER to set the alarm ON, press / , it displays: Time: 00:00, then press ENTER. *Choose the Buzzer mode, when the alarm goes on, there comes a audible sound, press ENTER button, the alarm will goes on again 5 minutes later. Press and hold the SLEEP button can stop the alarm. Set the presets, this option enables the unit to turn on from the preset station or the last listened station if the alarm mode is FM or DAB with preset stations. Set the alarm volume level, press / buttons to increase/decrease the volume level, press ENTER to confirm. After all the above steps, enter the SAVE interface, press ENTER to save the alarm 1. To cancel the alarms, enter the alarm setting interface, press ENTER to select off, then enter the SAVE interface to save the alarm off setting. Com manuals search engine Display information Press the INFO/MENU button to check the information. In FM mode, it displays: Radio text, program type, signal strength, and date. In DAB mode, it displays: DLS information, program type, station name, date, frequency, bit rate & mono/stereo, signal strength, signal error. Local ones contain stations that are specific to that area, e. [. . . ] to Store Stations , refer to General Operation. Station tuning Press and hold the INFO/MENU button to enter the <Audio setting>, press ENTER, then press the / to select one of the audio mode Stereo or mono or Mono only, at last press ENTER to confirm. Trouble Shooting * There is no sound from the speaker. Check if the volume level is turned up; * The sound is distorted. [. . . ]