User manual LENCO RT-2 CD

[. . . ] DON'T expose this unit to rain or moisture to prevent fire or electric shock hazards. DON'T continue to operate this unit if you have any doubt about it working normally, or it is damaged in any way, withdraw the mains plug and consult a qualified engineer. DON'T remove any fixed cover unless you are qualified to do so, and even then, disconnect from AC mains before you start. DON'T obstruct any of the ventilation slots in this equipment, or stand it close to curtains or on soft furnishings such as carpets. [. . . ] Tune in to the desired station by rotating the TUNING CONTROL. Adjust the volume level via the VOLUME CONTROL. Extend the FM TELESCOPIC ANTENNA to its full length or adjust the direction and position of the whole unit to obtain the best possible radio reception. HEADPHONE SOCKET This is a facility specially provided for private listening. Connect a 3. 5mm Headphone Plug of your Headphones/Earphones (note: not supplied) into the HEADPHONE SOCKET, and adjust the VOLUME CONTROL to a desired level. During the use of headphones/earphones, the built-in speakers are automatically disconnected. CD OPERATION HANDLING A DISC Although built to withstand a certain amount of the effects from dust, soil and scratches, discs should be treated with the care normally accorded to conventional analog discs (records). Always protect a disc against scratches, soil and dust etc. We recommend that during non-use periods the discs should be stored in the original case. Bear in mind the following points, since any dirt, scratches or warping of the disc can cause broken or intermittent sound and also noise. When holding the discs, take care not to touch the playing surface. Return them to their cases with the label surface facing up and push down lightly on the label surface. Do not place discs in the following locations: Near a heating device or a place where the temperature is high or in dusty areas. Do not write on the label surface using a ballpoint pen and do not stick labels on the CD. Wipe away any fingerprints or dust on the playing surface of a disc using a soft cloth. Bear in mind the following points: - Always wipe from the inside toward the outside of the disc. - Do not use conventional record cleaners, anti-static agents, benzene, thinner or other solvents. Note: CDs which can be played on this unit must have the following mark on them: This unit is compatible with CD-Rs/CD-RWs based on audio data. 4 USING THE CD LOADING A DISC 1. Open the CD door by pressing CD DOOR OPEN button. Place an audio CD into the tray with the label side facing up. The total number of tracks will appear in the display after 5 seconds. To remove the CD, press OPEN to open CD compartment lid, grasp the CD by its edges, and carefully take it out. Note: To ensure good system performance; wait until the disc tray completely reads the disc before proceeding. [. . . ] Note: Repeat function also can be done in stop mode. SPECIFICATIONS Power requirement . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . Power consumption . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . Operation temperature. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . RECEIVER SECTION Receiving Bands. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . [. . . ]