User manual LENCO SCD-38 USB

[. . . ] 8 Repeat play . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 9 Programmed play . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 9 Connecting a USB device . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 9 Playing other audio source through your set . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . [. . . ] If there is a scratch, dirt or fingerprints on the CD, it may cause a tracking error or skipping. · If the player is brought directly from a cold to a warm location, or is placed in a very damp room, moisture may condense on the lens inside the CD player section. Should this occur the player will not operate properly. In this case, remove the CD and wait about an hour for the moisture to evaporate. · To be completely disconnect the power input, the mains plug of apparatus shall be disconnected from the mains . As the disconnect devices is the mains plug of apparatus. · The mains plug of apparatus should not be obstructed OR should be easily accessed during intended use. · This CD player is designed to be played on a stable no vibration position. If you bump the set during CD play, the music will stop or skip for a few seconds. This is normal for this type of player. Scratched discs If your disc is badly scratched, it will not play. You may be able to repair the disc if you buy a disc polisher. Maintenance Cleaning the Lens If the lens becomes dirty, it may cause a skipping of sound during CD operation. Clean with a commercially available lens cleaner and blower or carefully wipe it with a soft dry cloth. Cleaning the Cabinet Clean the cabinet, panel and controls with a soft cloth slightly moistened with a mild detergent solution. Do not use any type of abrasive pad, scouring powder, or solvent, such as alcohol or benzene. 4 1. Exploring the unit & basic controls 1. 1. Parts on the front view side of the player LIFT TO OPEN STOP POWER PLAY/ FM S T. PAUSE PREV NEXT FOLDER PROG 12 14 8 3 1 5 6 7 4 10 2 9 14 11 13 1. Folder: During MP3/WMA playback, press FOLDER button to flash the current folder SN. , press FOLDER button to select next folder and play the first track in the folder. 2. 7. NEXT: skip next track; Press and hold the button to fast forward play during play mode PREV: skip to beginning of the current or previous track; Press and hold the button to fast backward play during play mode Repeat: repeat a track, folder or whole media Power LED indicator Display FM ST LED indicator LED on: main unit is in FM stereo mode LED off: main unit is in FM mono mode LED on: main unit is on LED off: main unit is off 8. 9. Stop: Press this to stop playback Play/pause: Press this to play CD or USB (When the unit is in CD/USB Mode, see function switch 16). When pressed in play mode, pause mode is set. PROG: Programming your desired tracks and its sequence to play 11. USB socket: To connect a USB devise 1. 2. Parts on the left view side of the player 16. VOLUME control: increase/decrease the volume 6 1. 3. [. . . ] Check the batteries (inserted correctly and new) Check the FUNCTION switch. There is no sound "- - -" or "nl" Appears in the display Adjust the volume Is the disk format supported?Is the CD compartment closed Take out the CD and leave the CD DOOR open for about an hour to dry moisture condensation CD does not play Make sure the CD is not scratched Clean the CD Make sure the FUNCTION switch is at CD/USB/AUX IN position If connected; disconnect the audio cable from the AUX IN jack. Clean the CD, or replace it if the CD is badly damaged The sound drips out Place the player in a location free from vibration Check if your batteries are okay CD does not play while the radio continues to play on battery power It is normal since the radio uses less power than the CD player Replace all the batteries with new ones, or bring the set near a window, or rotate the set/antenna General The unit does not turn on CD Player Radio The sound is weak or has poor quality 11 6. Specification AC 230V DC 9V (6 size "C" batteries) < 1 W (in standby mode: function switch is in OFF position) 9 W(during operation: function switch is in non OFF position) 4 ohms 1. 0W/channel 259 X 223 X 118 1295g(without batteries) Type: CD-DA , CD-R , CD-RW Format: CD , MP3 , WMA Power source Power consumption Speakers Output power Dimensions Weight Playable disc type and format Max tracks folders Radio Frequency range 7. [. . . ]