User manual LENOXX CD105

[. . . ] ® COMPACT DISC PLAYER AM/FM STEREO CASSETTE RECORDER MODEL CD-105 OPERATING INSTRUCTIONS PLAYS MUSIC COMPACT DISCS FULLY PROGRAMMABLE CD PLAYER WITH REPEAT RECEIVES AM/FM STEREO BROADCASTS RECORDS FROM CD, RADIO, OR BUILT-IN MICROPHONE FM STEREO INDICATOR 2 WAY POWER - AC/DC REQUIRES 8 SIZE C BATTERIES (not included) PLEASE READ CAREFULLY BEFORE USE IB-CD105(SY)-DG-E-041602 WARNING TO PREVENT FIRE OR SHOCK HAZARD, DO NOT USE THE PLUG WITH AN EXTENSION CORD, RECEPTACLE OR OTHER OUTLET UNLESS THE BLADES CAN BE FULLY INSERTED TO PREVENT BLADE EXPOSURE. TO PREVENT FIRE OR SHOCK HAZARD, DO NOT EXPOSE THIS APPLIANCE TO RAIN OR MOISTURE. WARNING RISK OF ELECTRIC SHOCK DO NOT OPEN The lightning flash with arrowhead symbol, within an equilateral triangle, is intended to alert the user to the presence of uninsulated dangerous voltage within the products enclosure that may be of sufficient magnitude to constitute a risk of electric shock to persons. The exclamation point within an equilateral triangle is intended to alert the user to the presence of important operating and maintenance (servicing) instructions in the TO QUALIFIED SERVICE literature accompanying the appliance. PERSONNEL. WARNING: TO REDUCE THE RISK OF ELECTRIC SHOCK, DO NOT REMOVE COVER (OR BACK). REFER SERVICING IMPORTANT SAFETY INSTRUCTIONS 1. [. . . ] Do not mix batteries (OLD and NEW or CARBON and ALKALINE, etc. ). The use of rechargeable batteries is not recommended for this set because their voltage and life is lower than standard batteries. Installation of batteries should be done by an adult only. 11. 12. 13. 16. SAVE THESE INSTRUCTIONS 3 IB-CD105(SY)-DG-E-041602 CHOOSING THE POWER SOURCES AC SOCKET You can use the AC power or batteries as a power source. To a wall outlet Battery compartment NOTE: One blade of plug and outlet is wider. TIP If the plug of the AC power cord does not match your outlet, do not force it. The plugs are polarized and only fit one way into the wall outlet and back of the set. 1. Connecting the AC power cord Insert one end of the supplied AC power cord (located in the battery compartment) into the socket located at the rear of the player, and the other end to the wall outlet. 2. Using the player on batteries Insert 8 size C batteries (not supplied) into the battery compartment. To use the player on batteries, disconnect the AC power cord from the player. TIP Replace the batteries when the display dims or when the player stops operating. Replace all the batteries with new ones. Before you replace the batteries, be sure to take out the CD from the player and remember to check the Battery Safety Instructions on Page 3. 4 IB-CD105(SY)-DG-E-041602 PLAYING A CD 1 3 5 2 4 Connect the supplied AC power cord or batteries (see page 4). 1 2 3 4 5 FUNCTION Slide the FUNCTION switch to CD position, the display will show two dashes --, then . Press the CD DOOR OPEN button to open it and place the CD in the CD compartment. The label side of the CD should face upward. The display will show the total tracks on that CD. Press the CD PLAY button. The PLAY/ PAUSE lamp will be steady on, the player plays all the tracks once. To change the sound effect, adjust the TONE knob to your taste. 5 Track PLAY/PAUSE number lamp IB-CD105(SY)-DG-E-041602 USE THESE BUTTONS FOR ADDITIONAL OPERATIONS FUNCTION SWITCH VOLUME CONTROL CD DOOR OPEN BUTTON TIP When CD play is paused, the PLAY/ PAUSE lamp will flash and no music will play. To resume play, press the PAUSE button again, the PLAY/PAUSE lamp will stop flashing and music will play. To Adjust the volume Stop playback Press or Adjust VOLUME control STOP PLAY/PAUSE The PLAY/PAUSE lamp will flash during pause. Press again to resume play after pause. Pause playback TIP If you bump the set during CD play, the music will stop or skip for a few seconds. This is normal for this type of player. Go to the next track Go back to the previous track FORWARDS BACKWARDS or Press and hold down while playing until you find the point. Press the CD DOOR OPEN button (press STOP first) Slide the FUNCTION switch to TAPE (POWER OFF) position Locate a point in a song Remove the CD Turn off the power 6 IB-CD105(SY)-DG-E-041602 LISTENING TO THE RADIO 3 1 5 4 2 Connect the supplied AC power cord or batteries (see page 4). 1 2 3 4 Slide the FUNCTION switch to RADIO position. Slide the BAND switch to the proper band position (AM, FM, or FM STEREO) that you want. Tune into the station you prefer using the TUNING control (at the back of the set). This FM STEREO indicator will light up when receiving FM Stereo broadcasts. 5 To change the sound effect, adjust the TONE knob to your taste. 7 IB-CD105(SY)-DG-E-041602 USE THESE BUTTONS FOR ADDITIONAL OPERATIONS 2 1 TIP To Adjust the volume Turn off the Radio · If the FM broadcast is Slide or Adjust VOLUME control Slide the FUNCTION switch to TAPE (POWER OFF) position noisy, slide the BAND switch from FM Stereo to FM position (MONO). · Next time you want to listen to the radio, just slide the FUNCTION switch to RADIO. The player automatically starts playing the previously tuned station. To improve broadcast reception Change position of the antenna for FM or FM Stereo. Move the set itself for AM. 8 IB-CD105(SY)-DG-E-041602 PLAYING A TAPE 1 2 3 Connect the supplied AC power cord or batteries (see page 4). 1 2 STOP Slide the FUNCTION switch to TAPE position. TAPE PLAY DIRECTION A Press the STOP button to open the tape compartment and insert a recorded tape. [. . . ] Magnetic fields may reduce the tape sensitivity or even erase the recording. Do not store tape for any length of time in a hot, moist or dusty place. Cleaning the Tape Heads Wipe the heads, the pinch roller and the capstan with a cleaning swab slightly moistened with cleaning fluid or alcohol after every 10 hours of operation for optimum playback and recording quality. After cleaning, insert a tape when the areas cleaned are completely dry. Cleaning the Cabinet RECORD/PLAY BACK HEAD PINCH ROLLER ERASE HEAD Clean the cabinet, panel and controls with a soft cloth slightly moistened with a mild detergent solution. Do not use any type of abrasive pad, scouring powder, or solvent, such as alcohol or benzene. CAPSTAN COTTON SWAB NOTE: In order to see and clean the head, you may have to press PLAY first. 17 IB-CD105(SY)-DG-E-041602 TROUBLE SHOOTING Problem The power is not on. General Connect the AC power cord to a wall outlet securely. [. . . ]