User manual LERVIA KH 1149 FAN HEATER

[. . . ] Should liquid happen to find its way into the appliance's casing, unplug the appliance immediately and have it repaired by a qualified professional. Do not at any time use the fan heater near water in, for example, bathtubs, showers, sinks or damp cellars. Being close to water poses a danger even when the appliance is turned off. Unplug the fan heater in case of malfunction and before cleaning. [. . . ] Do not allow children to use the fan heater unless under the supervision of an adult. Explain the dangers associated with using the appliance. · · · · · · · · · 5 Danger of tripping · · Place the power cord in such a way that no one will step or trip on it. Do not use an extension cord. Proper use The fan heater serves the purpose of heating and ventilating living spaces. This fan heater is designed solely for use in private households and may only be used in such. This also includes observance of all information in these operating instructions, particularly the safety instructions. All other uses are deemed to be improper and can result in property damage or even in personal injury. Kompernaß does not assume liability for damage caused by improper use. You can heat and ventilate living spaces using the fan heater. Figure A 1 2 3 4 5 6 7 8 Carrying handle Thermostat controller Heating grill Switch for the oscillating function Base Control light Timer Function switch Description 6 Operation The Remove the electric fan heater from the transportation packaging. Turn the function switch (centre) to the right. fan will turn on and the control light will illuminate in red. The fan heater is equipped with five switchable settings: Setting Condition of the fan heater 0 off fan, no heat output warm air flow very warm air flow hot air flow Setting the direction of air flow Tip the fan heater forwards in order to direct the air flow downwards. (Figure B, position a) or Tip the fan heater backwards in order to direct the air flow upwards. (Figure B, position b) Switching on the appliance and setting a time of operation Caution!Using the timer set the fan heater to "0" before plugging in the appliance. Otherwise you could damage the appliance. With the aid of the timer you can automatically shut off the appliance after a selected time. Should you not wish to automatically shut off the appliance, set the timer to "on". Should you wish the fan heater to automatically shut off after a certain period of time, set the timer to the desired time in minutes. 7 Setting the room temperature Set the timer to the desired period of operation or to "on" (see above). Turn the thermostat controller to maximum position. Once the required room temperature is reached. . . Turn back the thermostat controller until a , , click" can be heard and the fan heater is switched off. Should the room temperature sink below the set temperature, the fan heater will automatically turn on again. The fan heater will shut off automatically once the set room temperature has been reached. [. . . ] Hold the appliance with its back side facing down so that no filth can fall into the inside of the casing. 9 Rectifying malfunctions Symptom The fan heater will not turn on Possible cause and remedy The room temperature is higher than that which has been set with the thermostat controller. Set the thermostat controller to a higher setting. Check the fuses and reset them if necessary. Have the fan heater inspected by a qualified professional. The fan heater cannot be shut off. An electronic component is defective. [. . . ]