User manual LERVIA KH 368 CAR WAXER/POLISHER

[. . . ] Make sure that the tool cannot be inadvertently switched on. If danger arises, pull the mains plug immediately out of the mains socket. Never use the tool for a purpose for which it was not intended. Always watch what you are doing and proceed with caution. [. . . ] Always disconnect from the socket by pulling the plug and never the lead itself. If the original mains lead is not long enough, use an extension cable that is suitable for the purpose, tested and approved, with a current rating of at least 10 A. Look for the presence of an appropriate marking in accordance with the applicable standards on the extension lead. Take or send a defective tool to a specialist repair centre or to the importer's service department (see guarantee information). Do not store the tool to temperatures below 0°C or above 50°C. When using the waxer/polisher, always wear protective glasses. Always make sure that the bonnet used is firmly attached to the cushion. Before you switch on the tool, check that the cushion is not restrained and can move without causing any danger. Always check that the bonnet is safe to use. replace a torn or damaged bonnet immediately. Wait until the cushion is in good contact with the surface to be polished before switching on the waxer/polisher. be particularly careful when polishing edges and uneven surfaces. Do not use any abrasive as this can ruin your paintwork. Always follow this operating advice and keep the operating instructions safe in case you need them later. If you pass the tool on to anyone else, please ensure that you also pass on the instructions. Check that the mains voltage corresponds with that given on the rating plate. Devices suitable for 230 V supplies can also be used with 220 V supplies. First use/ normal use Follow the working methods given on the packaging. In order to achieve a thin complete covering do not use more material than is absolutely necessary. Too much wax does not achieve a better finish and you will have spent more time later removing the coating. [. . . ] Any difficult to reach corners or recesses may have to be completed later by hand. Take the bonnet off the waxer / polisher and use this bonnet for the corners and recesses. Use the second bonnet for final polishing or removing the wax. ⷠWhen working, always follow the instructions given for the wax/polish. [. . . ]