User manual LERVIA KH 4420 CORDLESS HAND VACUUM CLEANER

[. . . ] Before switching the hand vacuum cleaner on, make certain that the mains voltage corresponds to the voltage indicated in the technical data for the appliance. Never touch the power supply or the appliance with wet or damp hands. Do not use the power adapter with an extension cord; connect the power adapter directly to a power socket. Do not use the hand vacuum cleaner for vacuuming up liquids. · · · Delivery Contents Crevice nozzle Dust collector Dust filter Motor unit ON/OFF switch Charge indicator light Charging station / wall bracket Screws / plugs for wall installation Power adapter NOTE: The cordless hand vacuum cleaner model KH 4420 is delivered with uncharged batteries. [. . . ] · Take special care when using the hand vacuum cleaner on stairs. · Do not use the hand vacuum cleaner without the dust filter inserted. · Do not use the power adapter for a different product and do not attempt to charge this appliance with a different charging station. Only use the charging station supplied with this appliance. -5- KH4420_VacuumCleaner_IB_UK 18. 04. 2007 10:31 Uhr Seite 6 KH4420 Before the First Use 1. The cordless hand vacuum cleaner is powered by rechargeable Ni-MH batteries. Before using the cordless hand vacuum cleaner for the first time, the batteries must be charged for at least 24 hours. The batteries reach their full capacity after a charging time of 24 hours. The cordless hand vacuum cleaner can be used for its full operating time when the batteries are fully charged. Only place the appliance back in the charging station once the vacuum power becomes noticeably weaker. Important: · Once the charging process is completed, the appliance automatically switches to the charge maintenance function. However, in order to avoid possible damage to the batteries, do not leave the appliance constantly connected to the charging station . · Only place the appliance back on the charging station once the vacuum power becomes noticeably weaker. Important information about the battery In the event of a defective battery, please contact our service centre directly. Please refer to the guarantee card for the Authorized Service Outlet in your country. Charging 1. Insert the round plug of the power supply into the back of the charging station . Lock the plug by turning it anti-clockwise. Place the charging station next to a power socket and plug the power adapter in. The charging station can optionally be mounted on a wall with the supplied screws and plugs (see Chapter , , Mounting the wall bracket"). Vertical screw spacing 102 mm, screw diameter 3, 5 mm. You can insert the nozzle attachment into the socket on the charging station to store it. Place the hand vacuum cleaner in the charging station . The charge indicator light lights up red and the charging process begins. NOTE: Make certain that the on/off switch is in position "0" before starting the charging process. -6- Mounting the Wall Bracket 1. Using the wall bracket to mark the boreholes ensures the correct spacing. [. . . ] The nozzle attachment is used to clean narrow, hard-to-reach areas. Put the assembled hand vacuum cleaner in the charging station and start the charging process when the vacuum power is noticeably weaker. -7- KH4420_VacuumCleaner_IB_UK 18. 04. 2007 10:31 Uhr Seite 8 KH4420 Disposal Disposing of the batteries The hand vacuum cleaner is operated with rechargeable Ni-MH batteries that must be disposed of properly. Put the old batteries into your local recycling system. Follow the laws and regulations for disposal that apply in your country. [. . . ]