User manual LERVIA KH 3158

[. . . ] Before connecting the vacuum cleaner to the mains power supply you should ensure that the mains supply is 230 V ~ 50 Hz and is correctly equipped with a 16 Ampere fuse. The device must only be assembled, maintained and serviced when it is not connected to the power supply!Do not allow the device to come into contact with moisture!Otherwise there is a danger of death by electric shock! [. . . ] Vacuuming up fine dust results in static charges. You should therefore ensure permanent contact with the metal insert on the underside of the handle. This prevents the unpleasant effects of electrostatic discharge. The device should never be used without a dust bag or filter! A Initial Use A Assembly · Press the cover release { of the dust collection container and then open the cover. · Remove the dust bag holder u together with the dust bag i and ensure that the motor protection filter o and the exhaust air filter p are assembled as shown in illustration B. Then reinsert the dust bag holder u together with the dust bag i. · Close the cover and insert the suction hose connector } into the suction opening of the floor vacuum cleaner until it locks in place. · Insert the tapered end of the telescopic suction tube R into the connector of the floor nozzle I until it locks in place. Insert the handle Q into the telescopic suction tube R until it locks in place. · · · mCaution! · · · · · · Please avoid any damage to the power cord!During use the power cord should be unwound as far as the yellow marking!Otherwise there is a danger of damage from overheating!During use the power cord should be unrolled at least as far as the yellow marking, but not past the red marking!The power cord should only be removed from the socket by pulling the plug!Disconnect the vacuum cleaner from the mains immediately if there are any malfunctions!If the vacuum cleaner / power cord is damaged or broken it should only be repaired by authorised and trained specialists! a Adjusting the Telescopic Suction Tube · Keep the height adjuster Y held down in the direction of the arrow (see illustration D). · Adjust the telescopic suction tube R to the desired length and lock it in place. a Using the Suction Nozzles The floor nozzle I is suitable for the daily vacuuming of carpeted and hard floors. The floor nozzle I can be changed over manually - the brush strip is folded in and out. · Operate the changeover switch O of the floor nozzle in order to fold out the brush strip. This setting allows you to vacuum up loose dust, fluff and hairs on a smooth and solid surface, e. g. floor tiles. 8 GB/IE/CY Initial Use / Operation · Operate the changeover switch O of the floor nozzle to fold the brush strip in again. This setting makes it possible to vacuum up fluff and hairs on fibre and soft surfaces, e. g. For your individual room cleaning requirements the vacuum cleaner is supplied with a separate holder for three additional nozzles e. [. . . ] · Turn the vacuum cleaner off and disconnect the power cord A from the mains. · Press the release button { on the cover of the dust collection container and open the cover. · Remove the full dust bag i from the dust bag holder u by pressing the clamping lever. · Insert a new dust bag of TYPE KH 99 or type Swirl ® Y 101 ® into the dust bag holder. [. . . ]