User manual LEXIBOOK HPI030

[. . . ] You can even choose to wake up to your iPod® in the morning. the digital tuner automatically scans the AM and FM bands and locks in stations perfectly with no repetitive fine tuning required. And you can save 20 of your favourite stations (10 AM and 10 FM) in the preset tuner memory for immediate recall at the touch of a button. SmartSet® Automatic Time Setting System automatically sets the clock to the correct year, date, month, day, and time the first time you connect the system to your AC outlet, and after every power interruption. [. . . ] Using The Remote Control The remote control unit supplied with this system allows you to perform the following operations: · Select from among your preset stations. To operate the remote control point the handset at the REMOTE SENSOR on the front panel of the main unit and press the desired button on the handset. the effective operating range of the remote is approximately 15 feet. The effective operating angle is approximately 15 degrees to the left or right of dead center. The first time you turn your unit `On' the display will show FM 87. The first time you select the AM band the display will show AM 520 KHz. ) Tune to the desired station with the Tuning/Skip or buttons on the top panel or the / buttons on the remote control as follows: Manual Tuning Repeatedly press either the Tuning/Skip or buttons on the top panel or the / buttons on the remote control until the display shows the frequency of the desired station. ⷠAfter you press the Memory button the first time you must select a Preset Memory number and press the Memory button again within 10 seconds, while the memory number is flashing, or the station will not be memorized. ) Tune to the new station that you want to store. ) Press the Memory button and then press the Preset or buttons to select the Memory Number that you wish to change. The new station is now stored and the previous station is deleted from the memory. Or that the USB plug your iPod® shuffle inserted into the USB port in the docking area. If necessary set the Hold switch on your iPod® to the `Off' position. Depending on the setting of the Back Light Timer in your iPod® the display backlighting may turn `On' and the "Charging" or "Charged" indicator will appear in the display. It may begin playback with the first song in your library in alphabetical order by song name, or if the iPod® was only shut off for short time it may begin playback of the same song that was playing before it was shut off. NOTE: If the Power of this system is `On' and the iPod function is already selected then your iPod® will begin to play as soon as it is connected to the dock, as long as the iPod® HOLD switch is `Off'. If your iPod® enters the Pause mode when you connect it to the dock, press the Play/Pause button to begin playback. ) Once the iPod® is playing you can use the navigation controls on the iPod® to select among the menu items as usual. However you can only adjust the volume level by using the Volume +/­ controls on the top panel or remote control of this unit. The click wheel volume control on the iPod® cannot be used to control the speaker volume level of this system. ) To skip or search forward or back to the next or previous song you can use the Tuning/Skip or buttons on the top panel or the / buttons on the remote control. 8) The Play/Pause buttons on the top panel of this system and the remote Play/Pause button on your iPod®. [. . . ] Be sure to install a fresh lithium battery before you reset the clock, otherwise the clock will need to be reset each time the power is interrupted. If the lithium battery is exhausted and you experience an interruption in the AC power supply, the clock will reset itself to its initial default setting when the power is restored. If you notice that the time on your SmartSet® clock radio is completely incorrect, and the day indicator is also wrong, press the Date/Month button to see the date. if the date display is showing "01. [. . . ]