User manual LEXIBOOK HPI500

[. . . ] Thank you for purchasing this Lexibook HPI500 MP3 Music Station with SmartSet. This compact system has been designed with a powerful amplifier and matching high fidelity speakers to produce the kind of sound that you would only expect from a much larger, more expensive audio system. There is a built-in iPod® docking station that allows you to play any dockable iPod® model* through the speakers of this system. in addition while your iPod® is installed in the docking station the internal iPod® battery will be recharged automatically. [. . . ] The new station is now stored and the previous station is deleted from the memory. Antenna Information FM: The FM antenna is built in the AC power cord. You may have to extend and vary the direction of the AC power cord until you find the position that provides the best reception. aM: The AM bar antenna is inside the cabinet of the main unit. You may need to change the position of the main unit until you find the position that provides the best reception for your favorite AM stations. Listening To your "Dockable" iPod / Charging The Battery IMPORTANT!To prevent distortion during iPod playback you should go to the main Menu of your iPod, select the Settings Menu page, select the EQ Setting, and make sure that the EQ function is set to `Off'. this system provides an iPod docking station on the top panel. You can connect any dockable iPod, available as of January 2006, to the docking station and play your iPod through the speakers of this system. When you "dockable" iPod is in the docking area, the power to your device is being supplied by this system, not by the iPod's internal battery. In addition when your iPod is switched `Off' while resting in the dock the internal iPod battery is automatically recharged. NOTE: To prevent any possible interference between the iPod and the Tuner in this system, the iPod battery is automatically switched `Off" while you are listening to the radio. When the radio is `Off' the battery charging circuit switches `On' again automatically of whether the power button of this system is `Off' or `On'. Follow these steps to connect and listen to your iPod. We recommend that you start with the power to this system switched `Off': 1. ) Open the docking area cover by gently pressing downward on the cover and sliding it backward. ) Select the correct adapter for your particular iPod model from among the 5 different adaptors included (See page 43). Each adapter is engraved with the name and/or size of an iPod model. Place the selected adapter in the docking area so that the iPod 30-pin connector passes through the opening in the adapter. If you are using this system with an iPod nano will notice that the iPod 30-pin connector on this unit is not properly aligned with the opening in the ipod nano adapter. Before inserting the iPod nano adapter into the docking area you must slide the iPod 30-pin connector to the left position and then place the nano adapter into the docking area. After removing the nano adapter remember to slide the 30-pin connector back to the right position before attempting to install any iPod®adapter. [. . . ] 1" ( January 1st ) , you probably experienced a total memory loss. To reset the clock after a total memory loss, proceed as follows: 1. While holding the Date/Month and Time buttons, press the Tuning/Skip button to set the display to the correct year if necessary, and then release the buttons. While holding the Date/Month button, press the Tuning/Skip button to set the display to the correct Month and Date. [. . . ]