User manual LEXIBOOK RCD100SP

[. . . ] The wire-coloured brown must be connected to the terminal that is marked with the letter L. The wire-coloured blue must be connected to the terminal that is marked with the letter N. Do not connect anything to the earth terminal which is marked E, or You must make sure the mains lead is firmly secured under the cord clamp. Replace the plug or have the power lead assembly replaced if the fuse cover is lost. [. . . ] This product is designed for domestic use only. Any other use may invalidate the guarantee and might be dangerous. Place the equipment on a hard flat surface away from direct sunlight and heat sources, allow at least a 10cm gap all around. Don't obstruct ventilation slots, including those underneath, with soft furnishings. Overheating will shorten the life of the equipment and increase the risk of fire. Disconnect the mains supply and use only a lightly dampened soft cloth. Do not use chemical solvents or strong detergents as these may damage the cosmetic finish. Waste electrical and electronic products must not be disposed of with household waste. Please refer to the retailer from whom you purchased this item for disposal instructions. Packaging materials can be recycled using your local collection facilities. To prevent electric shock, do not remove any cover. If anything goes wrong, don't try and fix it yourself, get a qualified service agent to look at it. Do not expose this equipment to dripping or splashing or place any objects filled with liquids, such as vases, on the equipment. Never put a naked flame source on or near the equipment. Class 1 laser product This product contains a low power laser device. NOTE: You can use standard and single-size (3) CDs with this unit. NOTES: If a disc is inserted incorrectly, dirty, damaged or not present at all, and the PLAY/PAUSE button is pressed, Error or No Disc will appear in the display. As each track is played, the track number is shown in the display. To prevent damage to the disc, never open the CD door while the disc is rotating. Wait for the disc to stop before opening the CD door. Never touch the lens when the CD compartment door is open. After connecting the appliance to the supply and no buttons are pressed or if left in STOP mode for more than 30 seconds, the appliance will enter OFF mode (no display), you need to press the power button twice to turn the CD player back on. [. . . ] A little time spent in this way may save you the inconvenience of returning your equipment. Power System does not turn on, or does not respond to controls. Strange noises, does not work properly CD Disc won't play Remove batteries, pull the mains plug out for 5 minutes then re-connect and try again. If this does not work, leave the unit unplugged before seeking advice. [. . . ]