User manual LEXIBOOK SM1102

[. . . ] During use, this display may appear defective, especially if you are using the weather station for the first time or moving it. If this occurs, place the weather station flat on a table for ten minutes. This will allow the liquid crystals to fill up any empty spaces. English 3 INSTALLING THE BATTERIES PLEASE BE SURE YOU INSERT BATTERIES INTO THE REMOTE UNIT BEFORE YOU INSERT BATTERIES INTO THE MAIN UNIT. 1. Battery compartment. Copyright © Lexibook 2002 SM1102 English 7/2/04 4:21 PM Page 4 REMOTE UNIT English 4 The remote unit functions on two "AAA" batteries. [. . . ] These figures may vary with the environment and the level of interference. The main unit and the remote unit should be located a minimum of 2 metres away from any source of interference. Do not place the units close to a metal window frame. Any electrical device in the vicinity using a radio frequency of 434 MHz may cause interference. Extremes of temperature may also reduce the transmission range. If the temperature falls very low (below -25°C or -13°F) for a long period, transmission power will be too low because of the alkaline batteries. In these conditions, keep the remote unit indoors and wait for the temperature to rise again. MAIN UNIT 1. Battery compartment. SETTING THE CLOCK 1. Press the Mode button and keep it down until the hour starts to flash. Press the Hour button as many times as necessary to select the correct hour. Press the Minute button as many times as necessary to select the correct minute. Copyright © Lexibook 2002 SM1102 English 7/2/04 4:21 PM Page 7 SETTING THE ALARM FUNCTION 1. Press the Mode button (while the clock is displayed) to display the alarm function. Press the Hour button as many times as necessary to select the desired hour. Press the Minute button as many times as necessary to select the desired minute. Press the Alarm button to turn the alarm on or off. Its state is indicated by the AL symbol. If the alarm function is on, the alarm will sound at the specified time. Pressing the Mode button will activate the snooze function, and the alarm will then sound again five minutes later. Pressing any other button will deactivate the alarm. Press the Mode button three times to display the clock. SETTING CELSIUS OR FAHRENHEIT This model contains two temperature scales, degrees Celsius and degrees Fahrenheit. To choose either scale, press the °C/°F button. The temperature display will then switch from Celsius to Fahrenheit, or vice versa. OUTSIDE TEMPERATURE The SM1100 weather station can accommodate up to four remote units. [. . . ] If this method does not work, set up the main unit closer to the sensor or alongside it and hold down the button for a further five seconds. A beep is heard One of the alarms has been triggered. The weather station has a daily alarm that can be sounded, and gives off warning signals to indicate that the maximum or minimum temperature has been reached. *Please refer to the instructions for use on how to activate or deactivate these alarms. A remote unit installed alongside the main unit indicates a different temperature for the same location This is a perfectly normal and acceptable phenomenon. The temperature sensors are accurate to about +/-1. 7°C. [. . . ]