User manual LEXIBOOK ST5Z

[. . . ] TEXT_OFF - In TV mode, switches the TV back to regular view mode. Before programming and using your remote control, install 2 x AAA/LR03 alkaline batteries (not included). to do so , open the battery compartment located at the back of the remote. Make sure to install the batteries according to the polarity (+/- signs) indicated inside the battery compartment. [. . . ] You are now ready to set another device, with the same procedure. If your remote control's keys do not work, you did not find the right code. Try the next 3-digit code corresponding to your device's brand in the list: repeat steps 3 to 7, until your device responds correctly to the keys pressed on the remote. notes: Press the respective DEVICE button if you wish to stop the manual setup. If no button is pressed for more than 15 seconds, setup ends automatically and the LED goes off. If your device cannot be programmed using manual setup or its code is not in This search should be used only if Quick Search did not work. Press the respective DEVICE key on your remote control. Press the SET key followed by the POWER ( ) button on your remote control. Hold down both keys until the LED remains solid. Release both keys; the LED starts blinking. 5 codes are transmitted at a time; there is a 5-second period between each transmission, approximately 9 minutes in total. When your device switches off, then the correct code range has been found. Promptly press the respective DEVICE key to auto search within these five codes. Go back to your device and switch it ON again (with the original remote or using the front panel buttons). Aim the remote to your device: when your device switches off, the correct code has been found. During step 5, the SET button can be pressed to return to step 3 Check whether all applications of your device can be operated with the remote control keys. Tips for quick and auto search modes: - Some devices cannot be powered on/off using the remote control. In such case, use the PLAY button instead of POWER to check if the device responds to the remote control. - The search direction can be changed by pressing the CH+/- button. - All the function buttons except POWER and PLAY can be verified without exiting the quick search mode. If no button was pressed for more than 30 seconds, setup stops automatically, the LED goes off. Should your remote control still not work, check the codes list again and repeat the setup procedure (manual or code search) until you find the correct code. [. . . ] Disclaimer: In our constant concern for improvement, the colours and details of the product may differ slightly from those shown on the packaging. Your remote control stops working after the set-up is completed and successful. Some of your remote control keys are not working properly. Your remote control does not respond after pressing a key. [. . . ]