User manual LEXIBOOK TW30Z

[. . . ] Press and hold to lock and unlock the buttons. Press to confirm settings Microphone MENU button Press to change channels and to switch between modes MONITOR button Press and hold to check for signals on the current channel Monitoring two channels at once (Dual Watch) Press the MENU button THREE times DW appears on the display, as well as the currently selected channel. Press the or button to select a second channel 5 Cleaning and care To clean your TW30Z, use a soft cloth dampened with water. Do not use cleaners or solvents, which may cause damage not covered by the guarantee. UP and DOWN buttons ON/OFF button Press to change the speaker volume. [. . . ] Don't try to use two PMR handsets which are less than 1. 5 m (5 feet) apart. PMR446 is anas other people may-- always identify yourself when transmitting, be communicating on the same channel. Ring tone You can send Ring tone to other handsets within range and tuned to the same channel, to alert them you want to communicate with them. Press and release the CALL button You'll hear Ring tone for about 3 seconds, while the TRANSMITTING light is on. Any other handset within range and tuned to the same channel will hear Ring tone, and may decide to transmit to you. 1. Fitting a battery pack in each handset It's easier to fit the batteries without the belt clip in place. Pull the tab forward (away from the handset) to release the belt clip. Then lift the belt clip off. The backlight for the display Open the locking latch and slide off the battery compartment cover. To insert the battery pack, insert the lower edge first (A) . . then press the upper edge into the compartment (B), clicking the battery pack firmly into position. Lay the ribbon across the top of the battery pack. Replace the battery compartment cover, and firmly close the latch. To switch the backlight on and off: Briefly press the ENTER button Changing channels PMR has eight channels, numbered 1 to 8. To communicate with other PMR users within range, you must all have your handsets tuned to the same channel. Press the MENU button ONCE The current channel number flashes on the display. Press the or button to go to the channel you want You can also use Ring tone at the end of a transmission to signal that you've finished speaking. VOX (voice-activated transmission) mode Battery life The TW30Z has a built-in Power Saver feature to make the batteries last longer. But when you're not using the handset, it's best to switch it off to save battery power. You'll also find that the batteries last longer if you keep the backlight switched off when you don't need it. In VOX mode, your handset will transmit whenever it detects your voice (or other noise), without the TALK button pressed. It will transmit for at least 2 seconds, even if you stop talking. You may wish to use VOX mode if you're using a hands-free kit (see overleaf). The level of VOX sensitivity is shown by bars on the display. At the highest level (most bars), the handset will pick up softer noises (including background noise); at the lowest level, it will pick up only quite loud noises. Press the ENTER button to confirm Volume control To adjust the loudspeaker volume: Press the or button Transmitting and receiving ! [. . . ] But you can monitor the current channel for all sounds. Press and release the MONI button Your handset will pick up any signals on the current channel, including background noise. It will carry on monitoring for about 20 seconds, unless you press and release the MONI button again to stop it. You can plug a hands-free kit (not supplied as standard) into the socket on the top of your TW30Z handset. [. . . ]