User manual LEXICON I-ONIX FW810S

[. . . ] Owner's Manual IMPORTANT SAFETY INSTRUCTIONS WARNING FOR YOUR PROTECTION PLEASE READ THE FOLLOWING: KEEP THESE INSTRUCTIONS HEED ALL WARNINGS FOLLOW ALL INSTRUCTIONS THE APPARATUS SHALL NOT bE ExPOSED TO DRIPPING OR SPLASHING LIqUID AND NO ObjECT FILLED WITHI LIqUID, SUCH AS vASES, SHALL bE PLACED ON THE APPARATUS. DO NOT bLOCK ANY OF THE vENTILATION OPENINGS. INSTALL IN ACCORDANCE WITH THE MANUFACTURER'S INSTRUCTIONS. DO NOT INSTALL NEAR ANY HEAT SOURCES SUCH AS RADIATORS, HEAT REGISTERS, STOvES, OR OTHER APPARATUS (INCLUDING AMPLIFIERS) THAT PRODUCE HEAT. [. . . ] Most condenser microphones do require phantom power to operate. If you are unsure about the phantom power requirements for your microphone, consult your microphone's documentation or contact the manufacturer. This switch should be OFF if you are connecting any line-level source to the Mic/Inst or Mic Pre jacks. 4. DynaMIcS LeDS anD InPut LeVeL LeDS The top three rows indicate what dynamics are active for each input. The bottom three rows indicate signal presence (green) and level (yellow and red) for each input. 5. fIrewIretM LeD Indicates when a FireWireTM connection is present. 6. POwer LeD Indicates when the I-ONIX FW810S is turned on. 7. GaIn knOBS 1 anD 2 These knobs adjust the input gain levels for Mic/Inst 1 and Mic/Inst 2. 8. GaIn knOBS 3 ­ 8 These knobs adjust the input gain levels for Mic Pre 3 ­ 8 (the inputs located on the back panel). 9. heaDPhOne OutPut Jack Connect headphones here. 10. heaDPhOne LeVeL knOB Adjust headphone output signal level here. 11. MaIn OutPutS LeVeL knOB Adjust the main output signal level here. 3 4 rear Panel 12 3 456 7 8 1. POwer SwItch Turn the I-ONIX FW810S on or off here. 2. POwer Jack Standard 3-pin IEC power connector. 100-240V, 50-60Hz automatic switching to correct voltage range. 3. MIDI In anD Out The MIDI jacks provide MIDI input and MIDI output to and from your computer. Connect your MIDI keyboards, sound modules, and external controllers here. 4. S/PDIf In anD Out The S/PDIF in and out ports are unbalanced phono (RCA) connectors that transmit and receive either a 16-bit or 24-bit two-channel audio stream. S/PDIF ports may be found on many professional and consumer CD and digital audio recorders. It is recommended to use 75-Ohm coaxial cable for S/PDIF transfers and keep the cable length to a maximum of 10 meters to minimize interference and data dropout. 5. fIrewIretM POrtS Connect FireWireTM cables here. Either port can be used, with the other acting as Thru. [. . . ] Auto mode dynamically sets the Limiter Attack and Release based on the input signal. Attack knob The Attack parameter sets how quickly the Limiter starts to reduce the gain of the signal after it passes the Threshold. The Attack can range between 0. 1 mSec and 200 mSec. The Attack time is dynamically set while in Auto mode. Release knob The Release parameter is the rate at which the Limiter comes out of gain reduction once the signal is back below the threshold and the Hold time has elapsed. For example, if Release is set to 5 dB/Sec, and the signal has 10dB of gain reduction, the release time is 2 Seconds. [. . . ]