User manual LEXMARK OPTRA E312L

[. . . ] Optra E312 User's Guide June 2000 www. lexmark. com Edition: June 2000 The following paragraph does not apply to any country where such provisions are inconsistent with local law: LEXMARK INTERNATIONAL, INC. PROVIDES THIS PUBLICATION "AS IS" WITHOUT WARRANTY OF ANY KIND, EITHER EXPRESS OR IMPLIED, INCLUDING, BUT NOT LIMITED TO, THE IMPLIED WARRANTIES OF MERCHANTABILITY OR FITNESS FOR A PARTICULAR PURPOSE. Some states do not allow disclaimer of express or implied warranties in certain transactions, therefore, this statement may not apply to you. This publication could include technical inaccuracies or typographical errors. [. . . ] Do a long button press to select and save a setting for this menu. As the setting is saved, all operator panel indicator lights remain on for approximately 2 seconds. Turn off the printer to exit configuration mode. Appendix B: Advanced troubleshooting 69 If your printer lights look like this in configuration mode: Then your printer: Parallel Protocol setting is set to Fastbytes, the factory default. When the protocol is set to Fastbytes, the printer receives information at a much faster transmission rate, provided the host computer supports Fastbytes. When the protocol is set to Standard, the printer receives information at a normal transmission rate. The Press Button light is off when Parallel Protocol is set to Standard. Do a brief button press to change the setting (Fastbytes, Standard). Do a double button press to scroll to the next menu item, PPDS Activated. Do a long button press to select and save a setting for this menu. As the setting is saved, all operator panel indicator lights remain on for approximately 2 seconds. Turn off the printer to exit configuration mode. Factory Default Fastbytes 70 Appendix B: Advanced troubleshooting If your printer lights look like this in configuration mode: Then your printer: PPDS Activated setting is off, the factory default. Turn PPDS Activated on when working in applications using the PPDS datastream. There are two settings for PPDS Activated: On and Off. Do a brief button press to change the setting (On, Off). Do a double button press to scroll to the next menu item, Auto CRLF/LFCR. Do a long button press to select and save a setting for this menu. As the setting is saved, all operator panel indicator lights remain on for approximately 2 seconds. Turn off the printer to exit configuration mode. Factory Default Off Appendix B: Advanced troubleshooting 71 If your printer lights look like this in configuration mode: Then your printer: Auto CRLF/LFCR setting is off, the factory default. How the printer formats the end of a line depends on the computer system being used. Use this setting to select whether or not the printer automatically performs a carriage return (CR) after a line feed (LF) or a line feed after a carriage return. If the Press Button light is off, Auto CR after LF is Off and Auto LF after CR is Off. If the Press Button light is on, Auto CR after LF is On and Auto LF after CR is Off. [. . . ] Lexmark's process established to recycle toner cartridges and print units. The 6 lights and 1 button on the printer that are used to change printer settings and display printer status. A page description defining whether the printed text runs along the short edge (portrait) or the long edge (landscape) of the paper. R Ready. State of the printer in which it can receive, process and print data. Glossary X-3 reset. [. . . ]