User manual LG 24EN43VQ-B

[. . . ] € Block sunlight with blinds or curtains while you are operating the air conditioner. € Keep doors or windows closed tightly while you are operating the air conditioner. € Adjust the direction of the air flow vertically or horizontally to circulate indoor air. € Speed up the fan to cool or warm indoor air quickly, in a short period of time. [. . . ] - Please set it up not to bend because poor setup could take place if setup board bends. Please set up remote controller board fit to the reclamation box if there is a reclamation box. fAN SPEED TEMP ROOM TEMP Please check if connector is normally connected. Indoor Unit side Connecting cable 4 Please use extension cable if the distance between wired remote controller and indoor unit is more than 10m. 5 Please fix remote controller upper part into the setup board attached to the surface of the wall, as the picture below, and then, connecta with setup board by pressing lower part. - Please connect not to make a gap at the remote controller and setup board’s upper and lower, right and left part. <Connecting order> 2 Can set up Wired remote controller cable into three directions. - Setup direction: the surface of wall reclamation, upper, right - If setting up remote controller cable into upper and right side, please set up after removing remote controller cable guide groove. ❈ Remove guide groove with long nose. ‘ Reclamation to the surface of the wall ② Upper part guide groove ③ Right part guide groove Wall Side Wall Side When separating remote controller from setup board, as the picture below, after inserting into the lower separating hole using screw driver and then, spinning clockwise, remote controller is separated. - Please be careful not to damage the inside components when separating. If the installer setting mode is not set correctly, it can cause problems to the product, user injury or property damage. This must be set by an certificated installer, and any installation or change that is carried out by a non-certificated person should be responsible for the results. In this case, free service cannot be provided. Function Code Value - Some categories of the menu may not be displayed according to the function of the product, or the menu name may be different. A) ❊ Some contents may not be displayed depending on the product function INSTALLATION INSTRUCTION 11 ENGLISH Test Run Mode After installing the product, you must a test Run Mode. For details related to the Product manual. Setting Address of Central control It’s the functional to use connecting central control. 1 Press 1 Press button and button Simultaneouslly for more than 3 seconds. Button and button Simultaneouslly for more than 3 seconds. 2 Setup function code ’02’ pressing by button. 2 Setup figure ’01’ blinks Function Code Function Code Value Value 3 Set group number and indoor number. [. . . ] € It does not work to setup ESP value for very low/power step for some product. € ESP value is available for specific range belongs to the product.  The function of 2TH has difference operation characterics according to product. • Cooling: Operation of higher temperature by comparing indoor unit’s and wired remote controller’s temperature. [. . . ]