User manual LG 29EB73-P
Lastmanuals offers a socially driven service of sharing, storing and searching manuals related to use of hardware and software : user guide, owner's manual, quick start guide, technical datasheets... DON'T FORGET : ALWAYS READ THE USER GUIDE BEFORE BUYING !!!
If this document matches the user guide, instructions manual or user manual, feature sets, schematics you are looking for, download it now. Lastmanuals provides you a fast and easy access to the user manual LG 29EB73-P. We hope that this LG 29EB73-P user guide will be useful to you.
Lastmanuals help download the user guide LG 29EB73-P.
Manual abstract: user guide LG 29EB73-P
Detailed instructions for use are in the User's Guide.
[. . . ] CAUTION
It can result in minor injury or product damage when the directions are ignored
• Installation or repairs made by unqualified persons can result in hazards to you and others. Installation MUST conform with local building codes or, in the absence of local codes, with the Nation Electrical Code NFPA 70/ANSI C1-1003 or current edition and Canadian Electrical Code Part1 CSA C. The information contained in the manual is intended for use by a qualified service technician familiar with safety procedures and equipped with the proper tools and test instruments. [. . . ] Ex)
Connection Cable (1EA, 10m)
Screw (2 EA)
Owner's / Installation manual
1 Please fix tightly using provided screw
after placing remote controller setup board on the place where you like to setup. - Please set it up not to bend because poor setup could take place if setup board bends. Please set up remote controller board fit to the reclamation box if there is a reclamation box. fAN SPEED TEMP ROOM TEMP
Please check if connector is normally connected. Indoor Unit side
4 Please use extension cable if the distance
between wired remote controller and indoor unit is more than 10m. 5 Please fix remote controller upper part into
the setup board attached to the surface of the wall, as the picture below, and then, connecta with setup board by pressing lower part. - Please connect not to make a gap at the remote controller and setup board’s upper and lower, right and left part. <Connecting order>
2 Can set up Wired remote controller cable
into three directions. - Setup direction: the surface of wall reclamation, upper, right - If setting up remote controller cable into upper and right side, please set up after removing remote controller cable guide groove. Reclamation to the surface of the wall ② Upper part guide groove ③ Right part guide groove
Wall Side Wall Side
When separating remote controller from setup board, as the picture below, after inserting into the lower separating hole using screw driver and then, spinning clockwise, remote controller is separated. - Please be careful not to damage the inside components when separating. Setting Address of Central control
It’s the functional to use connecting central control. 1 Press 1 Press
button and button Simultaneouslly for more than 3 seconds. 2 Setup figure ’01’ blinks
Function Code Function Code Value Value
3 Set group number and indoor number. Button and button Simultaneouslly for more than 3 seconds After the setting has been completed. NOTE
• After setup, it automatically gets out of setup mode if there is no button input for 25seconds. When existing without pressing set button, the manipulated isn’t reflected. P
This is the functional that decides the strenth of the wind for each wind level and because this function is to make the installation easier. Thermistor
This is the function to select the temprature sensor to judge the room temperature. Button and button Simultaneouslly for more than 3 seconds After the setting has been completed. Button and button Simultaneouslly for more than 3 seconds After the setting has been completed. NOTE
• When setting ESP value on the product without very weak wind or power wind function, it may not work. [. . . ] Button and button Simultaneouslly for more than 3 seconds After the setting has been completed. NOTE
button and button Simultaneouslly for more than 3 seconds After the setting has been completed. Ceiling height of “Very high” function may not exist depending on the indoor units. 14 INSTALLATION INSTRUCTION
Remote Controller Master/Slave Setting
It’s a function for setting in group control, or 2remote controller control. [. . . ]
DISCLAIMER TO DOWNLOAD THE USER GUIDE LG 29EB73-P
Lastmanuals offers a socially driven service of sharing, storing and searching manuals related to use of hardware and software : user guide, owner's manual, quick start guide, technical datasheets...
In any way can't Lastmanuals be held responsible if the document you are looking for is not available, incomplete, in a different language than yours, or if the model or language do not match the description. Lastmanuals, for instance, does not offer a translation service.
Click on "Download the user Manual" at the end of this Contract if you accept its terms, the downloading of the manual LG 29EB73-P will begin.