User manual LG 29FU1RL

[. . . ] Colour Television OWNER'S MANUAL Please read this manual carefully before operating your set. Record model number and serial number of the set. See the label attached on the back cover and quote this information to your dealer when you require service. Model number Serial number : : P/NO : MFL62077602-EN (CW91A)(1004-REV02) Installation Power This set operates on an AC mains supply, the voltage is as indicated on the label on the back cover. [. . . ] See the `Connection of external equipment' section. AV1 : VCR connected to the Euro scart socket or AV IN 1 sockets on the set AV2 : VCR connected to the AV IN 2 sockets on the set (option). COMPONENT : DVD Player connected to the COMPONENT sockets on the set (option). Alternatively you can select the TV or AV mode by pressing the TV/AV button. In AV mode, to return to TV mode, press the D / E or NUMBER buttons. Note : If you cannot adjust the screen condition by degaussing, try it again after about 4 minutes. Sleep timer You don't have to remember to switch the set off before you go to sleep. The sleep timer automatically switches the set to standby after the preset time elapses. Repeatedly press the SLEEP button to select the number of minutes. The display - - - will appear on the screen, followed by 10, 20, 30, 60, 90, 120, 180 and 240. The timer begins to count down from the number of minutes selected. Auto AV switching (option) If your VCR outputs switching voltage when it is switched to playback with the VCR connected to the Euro scart socket. The set is automatically switched V1 to A mode when an AV signal is input. But if you want to keep on watching TV mode, press the D / E or NUMBER buttons. Press the TV/AV button to return to AV modes. Child lock The TV can be set so that the remote control handset is needed to control it. This feature can be used to prevent unauthorized viewing. With the lock on, the display Child lock on appears on the screen if any button on the front panel is pressed while viewing the TV. Note : a. To view the remaining sleep time, press the SLEEP button once. To cancel the sleep time, repeatedly press the SLEEP button until the display - - - appears. When you switch the set off, the set releases the preset sleep time. 4 On screen menus The dialogue between you and your set takes place on screen with an operator menu. The buttons required for the operating steps are also displayed. Setting up TV stations Auto programme tuning All stations that can be received are stored by this method. It is recommended that you use auto programme during installation of this set. Auto programme Menu selection 1. Press the MENU button and then D / E button to display each menu. Press the G or OK button and then D / E button to select a menu item. Change the setting of an item with the F / G button. You can move to the higher level menu with the MENU button and to move to the lower level menu press the G or OK button. [. . . ] The number of sub pages and the sub page displayed is, usually, shown on the screen below the time. When this button is pressed the stop symbol is displayed at the top left-hand corner of the screen and the automatic page change is inhibited. To continue press this button again. MIX Displays the teletext pages superimposed on the TV picture. To switch the TV picture off press this button again. TIME When viewing a TV programme, press this button to display the time at the top right hand corner of the screen. [. . . ]