User manual LG AJ-LDX6

[. . . ] AJ-LDX6 AJ-LAH2 LAMP OWNER'S MANUAL P/N : 3828VA0584J(0902_REV01) * Contact your dealer for replacing a new lamp. <Front panel of the Projector> The change interval of lamp may depend on the use environment of Projector. You can see the used lamp time in the CHECKING LAMP TIME section of the Menu. [. . . ] - Do not place the lamp near any heat source. - Make sure the new lamp is securely tightened with screws. If not, the image may be dark or there could be an increased risk of fire. - Never touch the lamp unit glass otherwise image quality may be compromised or lamp life maybe reduced. Replacing the Lamp 1 2 3 4 5 6 Turn off the projector and unplug the power cable. (Allow the lamp to cool for 1 hour before removing the used lamp from the projector. ) Lamp case screw Unscrew the screw from the lamp cover using a screwdriver. After lifting the lamp cover off, remove the two retaining screws on the lamp case with a screwdriver. Screws Lift up the fixed wire knob on the lamp. Pull out the handle slowly and remove the lamp case. Knob Insert the new lamp gently into the correct position. Make sure it is inserted correctly. 7 8 Tighten the screws you removed in step 3. (Make sure it is fixed hardly. ) Close the lamp cover and install the screws from step 2 to install the cover. (If the lamp cover is not installed correctly the unit will not power on. ) Using another manufacturers lamp may cause damage to the projector or lamp. Make sure the lamp cover is securely fastened. [. . . ] . * . 1 OK . ( 5 ) Lamp Use Time Total Lamp Use Time Lamp Reset Counter Lamp Use Time Reset Reset [Right Key] 21 hr. 0 Press Right to Reset Exit [MENU Key] 2 . . [. . . ]