User manual LG DC-9202SEU

[. . . ] The minimum safety distance between electric cook- top(hob) and the extractor hood is 450mm. But 600mm is recommended for better performance. When the hood is located above a gas appliance, the distance shall be AT LEAST 650mm. Check that the mains voltage corresponds to that indicated on the rating plate fixed to the inside of the hood. [. . . ] So it could not be installed in the recirculation version. Before installing the hood, remove 2 brackets of the top cover by releasing the screws. And refasten the screws in the holes. GB Wall Drilling and Bracket Fixing Draw a vertical line on the installing wall up to the ceiling, or as high as practical, at the center of the area in which the hood will be installed. Draw a horizontal line at the minimum distance of 600mm above the cook top. Mark the centers of the 7 points shown below figure. Drill ø 6mm holes at the centers marked. Place the chimney bracket (a) coinciding the bracket holes with the upper 2 holes. Secure the bracket using the screws provided. (M4 X L30) Place the body fixing bracket (b) coinciding the bracket holes with the lower 3 holes. Secure the bracket using the screws provided. (M4 X L30) Ceiling (a) 220 mm 210 mm 130 mm (b) 527 mm Product Bottom Line Min. (600mm is recommended for better performance) 595 mm 21~22 mm Cook top (Hob) Fig. 1 6 How to Install Hanging and fixing Mount the hood body on the body fixing bracket which was installed. (Fig. 2) Then align the center of body with the vertical line which was drawn. Adjust screws(a) to level the hood body. Secure the `Bracket of the body' to the wall by fastening 2 screws using washers into the wall plugs which was inserted. (b)(M4XL30) Body fixing bracket (a) (a) Bracket of the body GB (b) (b) Fig. 2 Connection Place the damper on the exhaust hole of the hood body. Apply the adhesive tape between damper and top surface not to be taken off during operation. Connect the pipe between damper hole of the hood body and one of the kitchen wall. The rigid or flexible pipe may be used, and the 120mm or 150mm pipe may be used. But, the choice is left to the installer. If the diameter of the pipe is 120mm, diameter reducer should be placed on the damper. (When using 150mm pipe, the reducer is not necessary. ) Connect the pipe with exhaust hole using the clamps. (The pipe and clamps are not provided. ) Connect the power plug to the main supply. Fig. 3 Chimney flue fixing Secure the upper chimney to the chimney bracket using the 2 screws provided. (M4 X L12) A little widen the sides of the lower chimney and put the side flange between the upper chimney and wall. [. . . ] 2) Push the button `M', then the speed level goes down by one step like `P->3->2->1->0' The motor operates for 10 minutes when activating this function. After 10 minutes it will turns off automatically. If you increase or decrease the motor speed during this function, this function will be deactivated. Indicates that grease filters need to be washed. [. . . ]