User manual LG EV193W

[. . . ] 3 Checking before use . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 6 Checking the name of the parts . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 7 Checking the remote controller . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 8 Basic function . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . [. . . ] depending on the models) Opening the panel Tightly grab top of the front panel and pull it down to open. Then slightly lift the panel up. 17 MAX_XSA_IBIM_DB98-33747A_E. pdf Cleaning the air conditioner and slide it down. Open the panel and put the A ter out. Clean the A ter with a vacuum cleaner or soft brush. If dust is too heavy, rinse it with running water. Insert the Ai lter back in its original position and close the front panel. Dry the Ai lter in a ventilated area. on the usage and environmental conditions. Power ( well-ventilated area. ) 18 MAX_XSA_IBIM_DB98-33747A_E. pdf Maintaining the air conditioner If the air conditioner will not be used for an extended period of time, dry the air conditioner to maintain it in best condition. Dry the air conditioner thoroughly by operating in Fan mode for 3 to 4 hours and disconnect the power plug. There may be internal damage if moisture is left in components. Before using the air conditioner again, dry the inner components of the air conditioner again by running in Fan mode for 3 to 4 hours. This helps remove odors which may have generated from dampness. ENGLISH Periodical checks Refer to the following chart to maintain the air conditioner properly. Type (1) Indoor unit Clean the condensate drain pan (2) Thoroughly clean the heat exchanger (2) Clean the condensate drain pipe (2) Replace the remote controller batteries (1) Clean the heat exchanger on the outside of the unit (2) Clean the heat exchanger on the inside of the unit (2) Clean the electric components with jets of air (2) Outdoor unit tightened (2) Clean the fan (2) Description Every 2 weeks Every 3 months Every 4 months Once a year Clean the condensate drain pan (2) air conditioner properly. : This check mark requires checking the indoor/outdoor unit periodically, following to the description to maintain the (1) The described operations should be performed more frequently if the area of installation is very dusty. (2) installation part in the manual. 19 MAX_XSA_IBIM_DB98-33747A_E. pdf Troubleshooting Refer to the following chart if the air conditioner operates abnormally. This may save time and unnecessary expenses. PROBLEM The air conditioner does not work at all. · Check if you have selected Auto/Dry/Turbo/ is set to Auto and you cannot adjust the fan speed. In these mode, fan speed The temperature adjustment is not working. Cool/Warm air does not come out of the air conditioner. working. Remote controller is not working. · Check if your batteries are depleted. · Make sure nothing is blocking your remote controller sensor. · Check that there are strong lighting apparatus near the air conditioner. Strong light which · Check if you press the Set button on the remote controller after you have set the time. If the indicator is still blinking, contact the service center. · Check if the appliance is running in a smoky area. Ventilate the room or operate the air conditioner in Fan mode for 1~2 hours. (We do not use smelly components in the air conditioner. ) · When an indoor unit indicator blinks, contact the nearest service center. [. . . ] Fix the outdoor unit in level to an appropriate support using anchor bolts. If the outdoor unit is exposed to strong winds, install shield plates around the outdoor unit so that the fan can operate correctly. · Secure the rubber leg to prevent the generation of noise and vibration. 'Y' mm 'X' mm Rubber leg Model 09/12 18 XY 543 319 660 340 Outdoor unit installed on the wall by rack · Ensure the wall will be able to suspend the weight of rack and outdoor unit; · Install the rack close to the column as much as possible; · Install proper grommet in order to reduce noise and residual vibration transferred by outdoor unit towards wall. Designed to cut o residual vibration from outdoor unit to rack. (not supplied with product) Soft rubber designed to cut vibration from rack to wall. [. . . ]