User manual LG F-1268QD

[. . . ] Instead, they are requested to directly contact a designated service center or the outlet at which the product was purchased. Never spill any kind of liquid into the unit. Should this happen, unplug or main switch off the unit and contact an authorized service center. Do not insert anything between the air outlet blades because the inner fan may be damaged and could cause injury. [. . . ] Otherwise, push the ventilation lever to the left and the closed position ( ). Result: The air simply circulates inside the room. Remote Control 2 If necessary, press the (On/Off) button. The air conditioner starts up in the Cool mode. Result: The unit beeps twice. Control Panel 3 If the FAN indicator is not lit up on the unit: Press the button on the remote control or Press the button on the unit one or more times until the FAN indicator lights up. The unit beeps each time you press the / button. Result: The air conditioner starts up in Cool mode. When the air conditioner is in the Fan mode, the temperature is not displayed; in this case, you do not need to set the temperature. 4 To set the fan speed to. . . Press the , or button on the remote control as desired. or Press the button on the unit one or more times until the the desired fan speed(F1, F2, or F3) is displayed. : Low Speed : Med Speed : High Speed 5 To control the direction of the air flow, refer to page 10. E-9 Removing Excess Humidity If the atmosphere in your room is very humid or damp, you can remove excess humidity without lowering the room temperature too much. Remote Control Control Panel 1 If necessary, press the Result: (On/Off) button. The air conditioner starts up in the Cool mode. The air conditioner is fitted with a protection mechanism to prevent the unit from being damaged when it is started immediately after being: Plugged in Stopped It will start up normally after three minutes. 2 If the temperature is not displayed at the top of the control panel, press button on the control panel one or more times until it the appears. 2 To stop the Energy Saving mode, press the Energy Saver button on the remote control or unit again. Result: The fan runs at all times, while the compressor cycles on and off. If you select the Sleep Timer in the Energy Saving mode, the Energy Saving will be cancelled and the air conditioner will start up in the Sleep Timer mode. Temperature and Humidity Ranges The following table indicates the temperature and humidity ranges within which the air conditioner can be used. Mode Cooling IndoorTemperature 21 C to 32 C approx. Indoor Humidity 80% or less If the air conditioner is used at. . . Higher temperatures Lower temperatures Higher humidity levels Then. . . The automatic protection feature may be triggered and the air conditioner stopped. A water leakage or some other malfunction may happen if the heat exchanger freezes. Water way condense on and drip from the surface of the unit if it is used for long periods. E-15 Cleaning Your Air Conditioner Be sure to clean the air filter periodically to maintain the air conditioner in the best condition for a long period of time. IMPORTANT When cleaning the air conditioner, turn it off and pull out the power plug. 1 Hold the front grille handle, slightly pull it to the left side and open the front grille. [. . . ] Aluminum house wiring may pose special problemsconsult a qualified electrician. This unit requires a separate circult, serving only this appliance. E-19 Installation Before installation, be sure to check the installation area or the air conditioner, and drain hose. Checkpoints prior to installation 1 Check the cabinet and front grille of the unit for any harmful defects such as scratches. - Refer to the specifications on the label attached to the unit. [. . . ]