User manual LG GBB539NSCPB

[. . . ] Electrical Connections (In the UK Only) Important The wires in this mains lead are coloured in accordance with the following code: GREEN AND YELLOW:EARTH BLUE:NEUTRAL BROWN:LIVE This appliance must be earthed Green and Yellow(Earth) Brown(Live) Blue(Neutral) Fuse Cord grip As the colours of the wires in the mains lead of this apparatus may not correspond with the coloured markings identifying the terminals in your plug, proceed as follows: The wire which is coloured Green and Yellow must be connected to the terminal in the plug which is marked with the letter E or by the earth symbol( ) or coloured Green or Green and Yellow. The wire which is coloured Blue must be connected to the terminal which is marked with the letter N or coloured Black. The wire which is coloured Brown must be connected to the terminal which is marked with the letter L or coloured Red. If a 13 amp(BS 1363) plug is used, fit a 13 amp BS 1362 fuse. Registration The model and serial number are found on the rear of this unit. [. . . ] Vita-Light is located at the rear of the vegetable drawer. • Viewing the laser out put with certain optical instruments (e. g. telescopes, binoculars, glasses, magnifyier) may pose an eye hazard. • The LEDs will operate automatically. Contact qualified service technician if there is any failure in LEDs. For Rail Model When separating the vegetable and opti-zone drawer, pull the vegetable toward you and then lift the drawer up with both hands. Door Alarm • When the door of the fridge is opened for a while, the alarm sounds. Please contact with the local service center if warning continue to sound even after closing the door. • You can choice door alarm on/off pressing door alarm button shortly. w CAUTION • Use of controls or adjustments or performance of procedures other than those specified herein may result in hazardous radiation exposure. How to separate the vegetable drawer On Off On Remove the lower basket from the door by lifting it up. Pull the drawer until it stops and slightly lifting it up pull it to take it out. 24 Operation ENGLISH Ice Making • Take out the twist ice maker, fill it up and put it back to it’s original location. Ice Making • Ice will be dropped into the ice storage bin by rotating Ice separation handle of ice making compartment. • You can make ice and also use this space as a storage space for Frozen food. Removing (1) (Twist ice maker) as shown in the picture. Note • Rotating the ice separation handle before ice is fully frozen may cause the remaining water drop into the ice storage bin to lump the ice together. • Take the ice out of the ice storage bin for use but do not pour water into the ice storage bin to freeze the water to ice. The ice storage bin can be Frozen and broken. • When the ice is full, it is designed for the ice to fall to the bottom in case the ice storage bin can not pulled out. Be careful not to store the ice too full. (1) (2) • Take out container with ice tray. Fill the ice tray to the water level and put it back. • You can place container with ice tray in upper or middle drawer of freezing compartment. • If ice cubes are required fast, press the «EXPRESS FRZ. » button. • To remove ice cubes, hold the tray at its ends and twist gently. Note TIP To remove ice cubes easily, run water on the tray before twisting. Defrosting • Defrosting takes place automatically. • The defrosting water flows down to the evaporating tray and is evaporated automatically. 25 Operation Water Dispenser (Optional) Features Water Dispenser (Optional) Dispenser Pad Cap Cover Dispenser Pad Water Tank Knob (Open/Close) Cap Assembly Tank Cap Tank Clamp Filling of WATER TANK How to Remove the Water Tank Water Tank • The assembly is the reverse of removal. [. . . ] This list includes common occurrences that are not the result of defective workmanship or materials in this appliance. Problem Fridge-Freezer does not operate Possible Causes • Power plug may be unplugged from the electric outlet. • House fuse has blown or circuit breaker has tripped. Check and/or replace fuse and reset circuit breaker. • Temperature control not set on proper position. [. . . ]