User manual LG GH24NS50

[. . . ] English Français Español Português Super Multi DVD Drive GH24 CAUTION : The laser used in the Super Multi DVD Rewriter can damage your eyes. To reduce the risk of electric shock, do not remove the cover (or back). There are no user-serviceable parts inside. Refer servicing to qualified service personnel. [. . . ] DVD-RW : Mitsubishi Kagaku Media, Verbatim are recommended. DVD+R : Mitsubishi Kagaku Media, Verbatim are recommended. DVD+RW : Mitsubishi Kagaku Media, Verbatim are recommended. DVD-RAM : Maxell, Panasonic are recommended. DVD+R DL : Mitsubishi Kagaku Media, Verbatim, Ritek are recommended. DVD-R DL : Mitsubishi Kagaku Media, Verbatim are recommended. * Compatibility problem in write/read function may occur with media depending on the media manufacturing quality. * For DVD±R 20x, 22x, 24x support media: Mitsubishi Kagaku Media. * For DVD+R DL 12X support media: Ritek 16x (MID Code: Ritek S06076(4ch)) * For DVD-R DL 12X support media: Mitsubishi Kagaku Media. (MID Code: MKM04RD30) * Upon the media condition or some of user's environment the maximum speed sometimes could not be guaranteed. 2 * Occasionally CD-R and CD-RW discs written by a CD-R/RW drive cannot be read by other CD drives*. These unreadable discs may need to be read using the CD-R/RW drive they were created with The disc written using the CD-R/RW drive might not be readable by CD-ROMs other than Multi-read compatible (UDF compatible) CD-ROMs Multiread compatible (UDF compatible) CD-ROMs are: 1. particularly those including Video playback) may require a considerably increased specification PC to give acceptable results. While this Super Multi DVD Rewriter can read DVD-video discs, decoding them to display on your pc's monitor requires separate MPEG decoding that is done by separate hardware (either an MPEG decoder card or MPEG decoding done by your video card), or separate software that you install to do MPEG decoding. For further details, refer to the documentation that comes with MPEG software. Location and Function of Controls Front Panel Rear Panel 4 1 2 3 1 2 1. SATA Data Connector (7 pin) 3 Installing the Drive Before installing the drive, please note the following points. You will need the following: · A screw driver of a suitable size to fit the securing screws for the drive unit. · The manual for the computer, so you can find the mounting positions for the SATA cable. Turn off all peripheral appliances of the computer and the computer itself, and disconnect their power cords from the wall sockets. Discharge any static electricity on your person by touching the computer covers, etc. Removing the Computer Cover Make sure all peripheral devices of the computer and the computer itself are turned off, and then remove the cover. Refer to the manual for the computer for details about removing the cover. [. . . ] · Is the disc loaded in the drive with the read/write surface facing the right direction?(label up) · Is the drive installed in the correct orientation?· Was the drive or disc moved from a low temperature environment to a high temperature environment?(There is a possibility of condensation on the lens in the drive or on the surface of the disc. ) · · When you call for service, be prepared to give as much information as possible of your system, environment, and the specific problem. [. . . ]