User manual LG GS-3159-PVHV1

[. . . ] T  he manufacturer is not responsible for issue from installing the product on severely wall or on the ceiling. *  eep the included accessories out of reach of babies or children as it can cause safety issues including K suffocation from swallowing the parts. * Make sure screws are tight against the wall, but do not overtighten. * Be careful not to install a TV that exceeds the weight restrictions of the wall mount. [. . . ] T You may also need an 8mm socket wrench or an 8mm drill bit for concrete. - The actual product may differ from the picture. 1 Fixating the mounting bracket on the TV If the screw will not fully tighten when using a guide spacer, recheck the assembly depth of the screw and  refer to the technical service manual. <Work procedure> Guide spacer Guide spacer screw 1.  heck to see if the display has screws installed into the C mounting holes.  ssemble the guide spacer and the guide spacer screw in A order as shown in the picture. -  Assemble the guide spacer to the set by tightening the screw. -  ighten the screw until the set, guide spacer and the screw T are fully pressing against one another. U -  se the "+" driver (Manual or motorized) when tightening the screw. 2 How to attach to masonry walls - Use the anchors for wall material of concrete, light concrete, strong natural stone, soft natural stone masonry brick and  hallow block that do not crack. Please follow the below direction. - Check the material of the wall and the thickness of the finishing. - When installing the product on the wooden wall, refer to page 5. -  hen installing the product on wall material not designated, install the product so that each fixated location can withstand W the pull out load of 70kgf (686N) and shear load of 100kgf (980N) or above. Anchor a b c d e Wall mount screw - Use the Ø8mm drill bit for concrete and hammer (Impact) drill. →  t this time, tighten the screw so that the wall, wall bracket and the wall mount screw are pressed against one another. A (Drywall can be damaged when tightened with excessive force, please be careful. ) →  hen tightening the screw use the "+" driver (Manual or motorized) or 8mm wrench. W 4 How to assemble the wall mount support and display - Always install the display with 2 or more people. Safety clip screw 1.  et the display with the guide spacer assembled on the wall S mount bracket on the wall in arrow direction. At this time, align the bottom assembly part and lift the set up lightly to align the top part. (When installing a Cinema Screen set (LM64**, LM66**, LM67**, LM76**, LM86**)to the wall mount, please refer to the installation section of the TV owner's manual. ) 2.  hen adjusting the location, assemble the provide safety clip as W shown in the picture to prevent the product from moving. Tighten the safety clip screw completely. If the safety clip is not tightened as shown in the picture, the product can fall off. → Pull on the bottom of the set to make sure the display is secure. [. . . ] →  hen installing a display rotated, only rotate the display 90 W degrees (portrait mode). (Only applies for VESA 200X200, 400x400) →  he clearance from the wall is 30mm ~ 41mm for this product. T Make sure to keep a certain level of distance from the wall so that excessive force is not applied on the cable or accessory. →  hen you push the product with excessive force, the product W can be damaged. [. . . ]