User manual LG GS-3159-PVHZ

[. . . ] *  eep the included accessories out of reach of babies or children as it can cause safety issues including K suffocation from swallowing the parts. * Make sure screws are tight against the wall, but do not overtighten. * Be careful not to install a TV that exceeds the weight restrictions of the wall mount. * Be careful with the tools used during installation to prevent accidents or damage. 3 ENGLISH Caution Installation method -  ools you will need : Phillips head "+" driver(Manual or motorized) Ø4mm drill bit for wood or steel / Level / Stud finder / Drill. [. . . ] - The actual product may differ from the picture. 1 Attach the mounting bracket to the TV If the screw will not fully tighten when using a guide spacer, recheck the assembly depth of the screw and  refer to the technical service manual. <Work procedure> Guide spacer Guide spacer screw 1.  heck to see if the display has screws installed into the C mounting holes.  ssemble the guide spacer and the guide spacer screw in A order as shown in the picture. -  Assemble the guide spacer to the set by tightening the screws. -  ighten the screw until the set, guide spacer and the screw T are fully pressing against one another. U -  se a Phillips Head driver (Manual or motorized) when tightening the screws. 2 How to attach to masonry walls - Use the anchors for wall material of concrete, light concrete, strong natural stone, soft natural stone masonry brick and  hallow block that do not crack. Please follow the below direction. - Check the material and thickness of the wall. - When installing the product on a wooden wall, refer to page 5. -  hen installing the product on wall material not designated, install the product so that each fixated location can withstand a W pull out load of 70kgf (686N) and shear load of 100kgf (980N) or above. Anchor a b c d e Wall mount screw - Use the Ø8mm drill bit for concrete and hammer (Impact) drill. Use a drill bit Ø8mm to drill a hole for the anchor location within a depth of 80mm ~ 100mm b. A (Drywall can be damaged when tightened with excessive force, please be careful. ) →  hen tightening the screw use the "+" driver (Manual or motorized) or 8mm wrench. W 4 How to assemble the wall mount support and display - Always install the display with 2 or more people. Safety clip screw 1.  et the display with the guide spacer assembled on the wall S mount bracket on the wall in arrow direction. At this time, align the bottom assembly part and lift the set up lightly to align the top part. (When installing a Cinema Screen set (LM64**, LM66**, LM67**, LM76**, LM86**)to the wall mount, please refer to the installation section of the TV owner's manual. ) 2.  hen adjusting the location, assemble the provide safety clip as W shown in the picture to prevent the product from moving. Tighten the safety clip screw completely. If the safety clip is not tightened as shown in the picture, the product can fall off. → Pull on the bottom of the set to make sure the display is secure. → When installing a display rotated, only rotate the display 90 degrees  (portrait mode). [. . . ] → When installing a display rotated, only rotate the display 90 degrees  (portrait mode). (Only applies for VESA 200X200, 400x400) → The clearance from the wall is 30mm ~ 41mm for this product.  When connecting cables and accessories, make sure that the product is installed at a sufficient distance from the wall to avoid stress on them. →  hen you push the product with excessive force, the product W can be damaged. [. . . ]