User manual LG LAC-2800

[. . . ] Always operate the vehicle in a safe manner. Do not become distracted by the vehicle while driving, and always be fully aware of all driving condition. Do not change settings, or any functions. Pull over in a safe and legal manner before attempting such operations. [. . . ] · Do not drop the control panel or otherwise subject it to strong impact. · Do not allow such volatile agents as benzine, thinner, or insecticides to come into contact with the surface of the control panel. 4 Control panel Protective Case Note Periodically wipe the contacts on the back of the control panel with a cotton swap moistened with alcohol. For safety, turn off the ignition before cleaning, and remove the key from the ignition switch. CAR CD/MP3/WMA Receiver 5 Installation Basic Installation Bend the claws according to the thickness of the dashboard ISO-DIN Installation Before installing, make sure that the ignition-switch is set to OFF and remove the terminal of the car battery to avoid short-circuiting. 1 2 3 4 Remove the existing receiver unit. Install the unit into the installation sleeve. 4 5 6 3 2 1 2 1 3 4 5 6 Control panel Control panel Slide the unit into the ISO-DIN frame. Slide the unit and frame into the dash opening. Install the dash panel or adapter plate. Install the control panel to the unit. Removing the existing receiver unit A If there is already an installation sleeve for the receiver unit in the dashboard, it must be removed. 1 2 Remove the rear support from the unit. Remove the control panel and trim ring from the unit. Insert the lever A into the hole on one side of the unit. Perform the same operation on the other side and pull the unit out from the mounting sleeve. A 3 6 CAR CD/MP3/WMA Receiver Connection Before connecting, make sure that the ignition switch is set to OFF, and remove the battery # terminal to avoid short circuits. 1 2 1 2 3 4 3 4 5 6 5 6 7 8 7 8 B A Power Antenna A5 Power Antenna(Blue) A6 Dimmer(Pink) A7 To Ignition(Red) A4 To Battery(+)(Yellow) A8 Ground(-)(Black) Control Relay Dimmer Switch Ignition Switch B1 B2 B3 BATTERY B B B B B B B B 1 2 3 4 5 6 7 8 Violet : Rear Right + Violet/ Black Stripe : Rear Right ­ Gray : Front Right + Gray / Black Stripe : Front Right ­ White : Front Left + White/Black Stripe : Front Left ­ Green : Rear Left + Green/ Black Stripe : Rear Left ­ B4 B5 B6 B7 B8 A1, A2, A3 : Not connected CAR CD/MP3/WMA Receiver 7 Basic Operation ON PLAYER 1. PWR/MUTE SRC VOLUME + or Note When XDSS+ is set to "Off", you can adjust the EQ settings. Adjusting the sound level Press SEL repeatedly to select the mode you want to adjust from volume, balance and fader. Note When EQ and XDSS+ is set to "Off", you can adjust the sound level (BAS, TRB) settings. Basic operation - more you can do Mute Press PWR/MUTE to cut the sound. To cancel it, press again. XDSS+ (Extreme Dynamic Sound System) Press and hold XDSS/EQ for more 2 seconds. (XDSS+ : Improves the treble, bass sound. ) Changing the general settings 1 Press MENU so that one of menu items appears. 2 Press MENU and press + or - to select one of the settings specified belows. 3 Press and hold MENU finish the setting. AUX (Auxiliary) ON / OFF It is possible to use auxiliary equipment with this unit. Activate the auxiliary setting when using auxiliary equipment connected to this unit. AUX (Auxiliary) 00dB / +6dB You can adjust the volume level of each source to prevent radical changes in volume when switching between sources. You may be surprised at a loud sound when you change the source from the external component to another source. [. . . ] Press DISP repeatedly during MP3/WMA/CD TEXT file playback. If there is no information, "NO TEXT" will be shown in the display window. Note · : The icon is displayed during MP3/WMA playback. · MP3/WMA Disc compatibility with this unit is limited as follows: 1. [. . . ]