User manual LG LAC6710

[. . . ] Veluwezoom 15, 1327 AE Almere, The Netherlands (Tel : +31-036-547-8940) 11 The unit is compatible with the steering wheel remote control. The function allows operation by sending the steering wheel remote control signal to the unit. For details, consult with your dealer. 2 CAR CD/MP3/WMA Receiver Safety Note CAUTION RISK OF ELECTRIC SHOCK DO NOT OPEN CAUTION : This product uses a Laser System. To ensure proper use of this product, please read this owner's manual carefully and retain it for future reference. [. . . ] · Remove the battery if the remote control is not used for a long period of time. · Do not leave the product in a hot or humid place. · Do not handle the battery with metallic tools. · Do not store the battery with metallic materials. 8 CAR CD/MP3/WMA Receiver Connection Before connecting, make sure that the ignition switch is set to OFF, and remove the battery # terminal to avoid short circuits. Wired remote input (Black): Hard-wired remote control adaptor can be connected (Not supplied/Optional). To Audio out To Audio in Front Left Front Right Rear Left (Sub-woofer Left) Rear Right (Sub-woofer Right) *Sub-woofer is optional. A 1 5 2 6 3 7 4 8 1 5 B 2 6 3 7 4 8 Power Antenna Amplifier (Optional) Control Relay A8 A7 A2 A1 A5 Power Antenna(Blue) Dimmer(Pink) To Ignition(Red) To Battery(+)(Yellow) Ground(-)(Black) BATTERY Dimmer Switch Ignition Switch B1 B2 B3 B4 B5 B6 B7 B8 B B B B B B B B 1 2 3 4 5 6 7 8 Violet / Black Stripe : Rear Right ­ Violet : Rear Right + Gray / Black Stripe : Front Right ­ Gray : Front Right + Green/ Black Stripe : Rear Left ­ Green : Rear Left + White/Black Stripe : Front Left ­ White : Front Left + A3 A4 Remote On(Blue/White) Phone Mute(Orange) Amplifier (Optional) A6 : Not connected CAR CD/MP3/WMA Receiver 9 Basic Operation ON PLAYER 1. PWR SRC Rotate PWR ON REMOTE POWER SRC VOLUME Adjusting the sound level Press SEL (SEL/MENU on the remote control) repeatedly to select the mode you want to adjust from VOL(volume), BAL(left/right speaker), FAD(front/rear speaker) and SUB(Sub-woofer:optional). To adjust sound quality, rotate PWR or on the remote control. press VOLUME Note When EQ and XDSS+ is set to "Off", you can also adjust the sound level (BAS(bass), MID(middle), TRB(treble)) settings. Basic operation - more you can do Mute Press VOL/MUTE (POWER cel it, press again. on the remote control) to cut the sound. To can- XDSS+ (Extreme Dynamic Sound System) Press and hold EQ/XDSS+. (XDSS+ : Improves the treble, bass sound. ) To cancel it, press and hold again. Checking the clock You can see the clock pressing DISP (DISP. The six strongest broadcast frequencies will be stored under preset button 1-6 in the order of their signal strength. To cancel, push the button up to U/AS. RDS broadcasting information. Press and hold the TA/PTY repeatedly for selecting each mode. Music group t Speech Group t Search off NO. CLASSICS, OTHER M JAZZ, COUNTRY NATION M, OLDIES FOLK M NO. TRAVEL, LEISURE, DOCUMENT Storing and recalling broadcast frequencies 1 Press BAND to select desired band you want to store. 2 Select the desired frequency and press one of preset buttons 1-6 and hold until the beep sound. 3 Repeat steps 1-2 to preset other stations. The next time, you press the same preset button, the radio station frequency is recalled from the memory. Connecting USB device ON PLAYER 1. Moving to another drive When connecting this unit to multi reader, press BAND (BAND/DRV on remote control) to go to the next drive. Each time you press the button, the driver modes changes. ON REMOTE VOLUME To scan the preset stations Push the button down to u/PS. To cancel, push the button down to u/PS. Rotate PWR To tune in the preset stations Press BAND to select the desired band and press the desired preset button 1-6 (preset button 1-6 on the remote control). Note · When a station is stored on the preset numbers on which another station of the same band has already been preset, the previously preset station is automatically erased. Note · If the USB device is already connected, press SRC (SRC on remote control. ) to select a source to USB. · Pause / Intro Scan / Repeat / Shuffle / . . . [. . . ] Refer to the page 10 for setting the clock. AUX (Auxiliary) ON / OFF It is possible to use auxiliary equipment with this unit. Activate the auxiliary setting when using auxiliary equipment connected to this unit. AUX (Auxiliary) 00dB / +6dB Only when you set AUX to ON as switching sources, you can adjust the volume level of each source to prevent radical changes in volume. [. . . ]