User manual LG LE2116D-NH

[. . . ] DIGITAL VIDEO RECORDER OWNER'S MANUAL MODEL: LE3116D LE3108D LE2116D LE2108D Before connecting, operating or adjusting this product, please read this owner's manual carefully and completely. AB28 CAUTION RISK OF ELECTRIC SHOCK DO NOT OPEN CAUTION: TO REDUCE THE RISK OF ELECTRIC SHOCK DO NOT REMOVE COVER (OR BACK) NO USER-SERVICEABLE PARTS INSIDE REFER SERVICING TO QUALIFIED SERVICE PERSONNEL. This lightning flash with arrowhead symbol within an equilateral triangle is intended to alert the user to the presence of uninsulated dangerous voltage within the product's enclosure that may be of sufficient magnitude to constitute a risk of electric shock to persons. The exclamation point within an equilateral triangle is intended to alert the user to the presence of important operating and maintenance (servicing) instructions in the literature accompanying the product. FCC WARNING: This equipment may generate or use radio frequency energy. Changes or modifications to this equipment may cause harmful interference unless the modifications are expressly approved in the instruction manual. [. . . ] (Minimum 4 length, Maximum 8 length). Note: Remember the password. If you forget the password please contact an authorized service center or the store where you purchased the system. Update l Button - ON: Makes a sound when using the buttons. Sensor - ON: Makes a sound when a sensor occurs. Motion - ON: Makes a sound when a motion is detected. System The update feature allows you to upgrade DVR software and add/upgrade PTZ protocols. In this case, the current DVR settings are not deleted or replaced during the update process. l l l - ON: Makes a sound when a cooling fan is not activated or the HDD has bad sector. Note: The buzzer is a low sound on this unit. If you want to make a loud sound, connect an external alarming device to the RELAY-OUT terminals (ex. Select one of the following: Select SYSTEM S/W to upgrade DVR system software. · Select PTZ PROTOCOL to update the DVR protocols. Choose the media from which to perform the update: USB: Select USB, and then insert the USB drive into the DVR. All USB devices must be disconnected before you can use the USB drive. · NETWORK: Select NETWORK, and then do following: 1. The DVR network settings must be configured and you must know the update server's IP address. Select Update to start the update process. Select OK to begin the update process or click Cancel to stop and exit. After the update process is completed, the system displays the Restart the system dialog box. · · User You can register a new user with various access rights to the DVR or client program. l ID: Enter the new user ID using the virtual keyboard. Level: Select the level of the new user. l 37 HOOKUP AND SETTINGS Configuration l Overwrite: - ALL: Overwrite recording is possible when the normal partition and event partition of HDD have fully recorded. - NORMAL PARTITION: Overwrite recording is possible for normal partition of HDD when the normal partition of HDD has fully recorded. - EVENT PARTITION: Overwrite recording is possible for event partition of HDD when the event partition of HDD has fully recorded. - OFF: Do not use overwriting. l l Full Warning: When the HDD has overflowed a warning message is displayed. [. . . ] The PTZ camera control is not available for a normal user. REFERENCE 67 Symptoms Resolutions E-mail reception failed without SMTP server setting. · Make sure the network is correctly set. · Make sure the mail address is input correctly. [. . . ]