User manual LG LH-D6235

[. . . ] REFER SERVICING TO QUALIFIED SERVICE PERSONNEL. Cleaning Unplug this television receiver from the wall outlet before cleaning. Do not use liquid cleaners or aerosol cleaners. Do not use attachments not recommended by the television receiver manufacturer as they may cause hazards. [. . . ] If you want to stop auto programming, press the ENTER (A) button. Only the channels searched up to that time are memorized. Notes: ·If the programmed signal has poor quality, memorize again in the Auto prog. ·AUTO PROGRAM stores all receivable channels regardless of receiving signal (RF, Cable). ·If channels of general wireless TV and cable TV are duplicated, press the number buttons (0 ~ 9) to change as . Channels of general wireless TV Channels of Cable TV Turning on/off the TV Press the POWER (or ON/OFF) button on the set. At this time, the set switches to standby mode and the standby indicator lights up in red. To switch the TV on from standby mode, press the TV/VIDEO, CH D / E button on the set or POWER, TV/VIDEO, CH D/E or number button on the remote control. A channel number will be displayed on the screen. The on-screen display will disappear after a few seconds. Press the POWER button on the remote control. To switch the TV off, press the POWER(ON/OFF) button on the set. Using the MENU button 1. Notes: ·If you don't press any button within 2 hours after turning on the TV set by ON TIMER function, the set will be automatically switched back to standby mode. ·TV must be in standby mode for the On timer to work. Auto Demonstration (some models) Auto demonstration allows you to review all the menus programmed in the TV set. Setting the Sleep Time You don't have to remember to switch the TV to standby mode before you go to sleep. The sleep timer automatically turns the TV off after the preset time elapses. Press the SLEEP button to select the desired sleep time. Each time you press this button, the sleep time is displayed one by one as shown below. The timer begins to count down from the number of minutes selected. --- ¡10 ¡20¡30 ¡60 ¡90 ¡120¡180¡240 Notes: ·After a few seconds, the desired sleep time will disappear and be operated automatically. ·To view the remaining sleep time, press the SLEEP button once and the remaining sleep time will be displayed. ·To cancel the sleep time, select the SLEEP --mode by using the SLEEP button. Favorite channel memory Favorite channel memory is a convenient feature that lets you quickly scan up to eight channels of your choice without having to wait for the TV to scan through all the in-between channels. To select the favorite channel, repeatedly press the FCR (Favorite Channel Review) button. Eight channels programmed appear on the screen one by one. Adjusting the Fine This function is to adjust the picture if poor signal received from broadcasters causing horizontal stripe, twisted picture, no color, and/or noise. [. . . ] OUT JACKS: Connect external equipment inputs (VCR, Audio amplifier) to these outputs for recording or monitoring the selected program. §/ EARPHONE JACK (some models): In some models, this jack is located on the front or side of TV. Note: This TV is programmed to remember which mode it was last set to, even if you turn the TV off. Connect the audio/video output jacks of the VCR to IN 1(A/V) jacks on the side or back of TV. [. . . ]