User manual LG LPT-DW113P

[. . . ] Network Camera Owner's Manual MODEL: LPT-DW113P Before installing and using the camera, please read this owner's manual carefully and retain for future reference. RISK OF ELECTRIC SHOCK DO NOT OPEN CAUTION CAUTION: TO REDUCE THE RISK OF ELECTRIC SHOCK DO NOT REMOVE COVER (OR BACK) NO USER-SERVICEABLE PARTS INSIDE REFER SERVICING TO QUALIFIED SERVICE PERSONNEL. FCC WARNING: This equipment may generate or use radio frequency energy. Changes or modifications to this equipment may cause harmful interference unless the modifications are expressly approved in the instruction manual. The user could lose the authority to operate this equipment if an unauthorized change or modification is made. REGULATORY INFORMATION: FCC Part 15 This equipment has been tested and found to comply with the limits for a Class A digital device, pursuant to Part 15 of the FCC Rules. [. . . ] - Hostname: Enter the registered host name of the No-IP web site. - ID: Enter the registed user ID of the No-IP web site. - Password: Enter the registered password of the No-IP web site. 9003, TCP You can use the port number between 1024 and 65535. The recommended port number is from 49152 to 65535. (The port number from 1500 to 1510 are used for this camera. ) Note: After change the options, you must click [Save] button in the option to confirm the settings. Additional Information Client Program Operating Setup configuration - User Port: Select and change the port number you want. Note: Installation Connections Introduction Network Setup Note: For more detail information, visit the No-IP web site or to register the No-IP web site see page 41. MAC Address: Displayed MAC address of the camera. Port Setup: - Default Port: Select when you use the default port. The factory default port is as shown below. Video & Audio Setup · · · Video Setup - CH: Display the channel number. NTSC 704x480 704x240 352x480 352x240 PAL 704x576 704x288 352x576 352x288 Audio Setup - Disable: Select when the audio is not used. - Audio Enable: Select when the simplex audio transmission from the microphone of the camera to the speaker of the computer is available. - Interactive Audio Enable: Select when the mutual audio transmission is available. Audio Volume Setup You can set the audio volume level of the connected speaker and/or microphone on the camera. The speaker and/or microphone of the computer is available to adjust the volume level using the Web Viewer program. - Input (Mic/Line): Select the input audio volume level. - Output (Speaker): Select the output audio volume level. - Frame Rate: Select the frame rate. The frame rate is the number of images to send per second. > PAL: 1, 2, 3, 4, 5, 6, 7, 8, 12 or 25. > NTSC: 1, 2, 3, 4, 5, 6, 7, 10, 15 or 30. - Bit Rate: Select the bit rate form between VBR and CBR. > VBR (Variable Bit Rate): Select the picture quality among High, Normal and Low. > CBR (Constant Bit Rate): The images are recording or viewing by selected bit rate. [. . . ] Connect the cables and face the "FRONT" on the Ceiling Mount assembly to the place that you wish to watch. Attach the bell bracket with the Ceiling Mount Assembly. 7. Connect the safety wire and connector. 8. Fit the groove line of camera body to the groove line of the bell bracket and turn right to attach each other. 9. [. . . ]