User manual LG LS-H0964DM1

[. . . ] Keep children away from the unit. 5 ALWAYS ensure that the power cable is in good condition. If the power cord is damaged in any way, it must be replaced by an authorized service technician. Do not use an extension cord with this or other appliance. 6 Do NOT attempt to repair the unit yourself. If it is damaged in any way, contact: x An authorized service center x The dealer from whom you purchased the air conditioner. 7 Do NOT place any blocking objects in front of the unit. [. . . ] Result: x The air conditioner starts up in Cool mode. 3 You can change modes at any time. To adjust the temperature, press the or button on the remote control one or more times until the required temperature is displayed. To adjust the temperature, press the or button on the unit one or more times until the required temperature is displayed. Possible temperatures are between 18°C and 30°C inclusive. x Each time you press the temperature buttons: Result: ­ The temperature is adjusted by 1°C and displayed on the control panel ­ The unit beeps x The air conditioner starts cooling if the room temperature is higher than the selected temperature. 4 To set the fan speed to. . . x Press the button on the remote control. or x Press the on the unit until the indicator lights up x Press the button on the remote control. or x Press the on the unit until the indicator lights up x Press the button on the remote control. or x Press the on the unit until the indicator lights up Med Low Result: E-8 Each time you press a button, the unit beeps. 5 To control the direction of the air flow, refer to page 10. Airing Your Room ENGLISH If the atmosphere in your room is stale, you can air it using the Fan feature and if necessary, evacuate the stale air outside. 1 If you wish to evacuate stale air outside, push the ventilation lever on the front of the unit to the right and the open position ( ). Result: The air inside the room circulates and stale air is evacuated outside. ). Otherwise, push the ventilation lever to the left and the closed position ( Result: The air simply circulates inside the room. Remote Control 2 If necessary, press the (On/Off) button. x The operating mode indicator (COOL or FAN) on the Result: unit comes on. x The fan will continue to run for a short time after the compressor cycles off. 2 If you would like the air conditioner to run in Fan mode, do not press the Energy Saver button. You cannot use the Fan mode in the energy saving mode. To stop the energy saving mode, press the Energy Saver button on the remote control or unit again. Result: The fan runs at all times, while the compressor cycles on and off. If you select the Sleep Timer in the Energy Saving mode, the Energy Saving will be cancelled and the air conditioner will start up in the Sleep Timer mode. Temperature and Humidity Ranges The following table indicates the temperature and humidity ranges within which the air conditioner can be used. Mode Cooling Indoor Temperature 21°C to 32°C approx. Outdoor Temperature 21°C to 43°C approx. 21°C to 54°C approx. (Middle East) Then. . . The automatic protection feature may be triggered and the air conditioner stopped. A water leakage or some other malfunction may happen if the heat exchanger freezes. Water may condense on and drip from the surface of the unit if it is used for long periods. Indoor Humidity 80% or less If the air conditioner is used at. . . [. . . ] Check that there are no obstacles between you and the unit. Replace the remote control batteries if necessary. Check that you are close enough to the unit (seven metres/yards or less). Check that you are pointing the remote control at the remote control sensor on the unit. [. . . ]