User manual LG LSW100B

[. . . ] * When installing/using the wall mount, be cautious of product damage and avoid accidents. * If you have not fully read and understood the installation manual, do not install the product and contact the dealer to have a specialized installer install the product for you. * Even if you are not a specialized installer, it is advantageous to have experience in mechanical or construction field in completely understanding this manual and installing the product. [. . . ] Attach the bracket to the back of the display as shown above. Use a Phillips head "+" screwdriver to tighten the screws. - At this time, be careful to prevent the set from falling down. - Make sure the screws are fully tightened to the bracket and display. 4 - Use the anchors for wall material of concrete, light concrete, strong natural stone, soft natural stone masonry brick and hallow block that do not crack. Please follow the below direction. - Check the material of the wall and the thickness of the finishing. - When installing the product on the wooden wall, refer to page 6. - When installing the product on wall material not designated, install the product so that each fixated location can withstand the pull out load of 70kgf (686N) and shear load of 10kgf (980N) or above. Anchor a b c Wall mount screw d e - Use the Ø8mm drill bit for concrete and hammer (Impact) drill. Use a drill bit Ø8mm to drill a hole for the anchor location within a depth of 80mm ~ 100mm. (When inserting the anchor, use a hammer. ) d. Set the wall mount on the wall by aligning to the location of the hole. and, set the angle adjusting part to face upward. Align the wall mount bolt to the hole and tighten it. Then, fasten the bolts at torque of 45 - 60 kgf/cm. 4 How to install the wall mount <When installing on a masonry wall> When you separate the 4 screws on the wall mount connected to the wall bracket for use with a wooden wall, it is much easier to install the product. A Wall mount screw Separate the wall mount screw. When installing the product on a masonry wall, turn the 4 screws on the A part counterclockwise to separate the screw and bracket. After aligning the wall bracket to the location to install, mark the part to screw on the wall and then remove the wall bracket. [. . . ] Use some type of cable banding device to hold all the cables together. Attach the set protection cushion to mitigate the impact between the wall and the set when adjusting the angle. Attach the set protection cushion as shown in the picture. Cable arrangement and set protection cushion ± 5° ± 5° 6 Product specification [ Unit : mm ] -15° ~ +15° ± 2° -15° ~ +15° ± 2° <With the bracket removed. > Max. [. . . ]