User manual LG LSW130B

[. . . ] Also follow the designated directions for the depth of the hole. If the product is installed without following the designated method, the product may be unstable and cause a safety issue. s s Do not install the product near any object that may cause vibration. Do not install the product near any high voltage power cable or power source. Unplug the power cord from the power outlet before installing the product. If you install the product with the power cord plugged, it can cause an electric shock or a fire. Do not install the product with bare hands. Always wear proper work gloves. It can cause an injury. Do not allow the video connectors connected to the display to press against the wall. [. . . ] Separate the set bracket as shown in Fig. 3. 2 Attaching the mounting bracket on the TV Make sure the screws are fully tightened to the bracket and display. If the screws will not fully tightened, they might be too long or the wrong size. VESA 100X100 / VESA 200X100 is supported. If needed, you may refer to the display's user manual to verify the display has one of the supported VESA formats. Screws are included for the following models: M4 X 10 mm :  9LED LCD TV/LCD TV/LED TV 1 22LED LCD TV/LCD TV/LED TV 24LN4*/26LN4*/28LN4*/29LN4* M4 X 14 mm :  6LED LCD TV/LCD TV/LED TV 2 32LED LCD TV/LCD TV/LED TV Bracket to attach to the display VESA 200 VESA 100 VESA 100 Install the PVC washer between the brackets and the display on the following models : 32LE46*/32LE53*/32LE55* But for 26LE53*/26LE55* model, this is provided as TV component. <Work procedure> 1. Check to see if the display has screws already installed into the VESA mounting holes.  ttach the bracket to the back of the display as shown above. Use a Phillips head "+" screwdriver to tighten the A screws. - At this time, be careful to prevent the set from falling down. - Make sure the screws are fully tightened to the bracket and display. 4 -  Use the anchors for wall material of concrete, light concrete, strong natural stone, soft natural stone masonry brick and hallow block that do not crack. Please follow the below direction. - Check the material of the wall and the thickness of the finishing. -  hen installing the product on wall material not designated, install the product so that each fixated location W can withstand the pull out load of 70 kgf (686 N) and shear load of 100 kgf (980 N) or above. Anchor a b c Wall mount screw d e - Use the Ø8 mm drill bit for concrete and hammer (Impact) drill. Use a drill bit Ø8 mm to drill a hole for the anchor location within a depth of 80 mm - 100 mm. [. . . ] Attach the set protection cushion to mitigate the impact between the wall and the set when adjusting the angle. Attach the set protection cushion as shown in the picture. Cable arrangement and set protection cushion ± 5° 6 Product specification [ Unit : mm ] -15° - +15° ± 2° -15° - +15° ± 2° Max. Min. Model Name Width (mm) Height (mm) Depth (mm) Weight (kg) Wall Mount VESA Specification Max. [. . . ]