User manual LG LSW420BX

[. . . ] *  his product is designed to be mounted to walls that use standard intervals between the studs. T * nstall the screw to attach the wall mount so that it can be assembled at the center from both ends of I the studs. Use of stud finder, a separate device, is recommended. [. . . ] Set the wall mount on the wall by aligning to the location of the hole. and, set the angle adjusting part to face upward. Align the wall mount bolt to the hole and tighten it. Then, fasten the bolts at torque of 45 - 60 kgf/cm. 3 How to install the wall mount <When installing on a masonry wall> →  hen you separate the 8 screws on the wall mount connected to the wall bracket for use with a wooden wall, it is much easier W to install the product. A A →  hen installing the product on a masonry wall, turn the 8 W screws on the A part counterclockwise to separate the screw and bracket. →  fter aligning the wall bracket to the location to install, A mark the part to screw on the wall and then remove the wall bracket. → Refer to page 4 to attach the wall bracket. → Use a level to check whether the wall mount is level. Separate the wall mount screw. 4 Wall mount screw →  the screw cannot be assembled in the designated location If inevitably, it can be assembled by rearranging to the closest location. But, do not change 2 or more locations from the designated spot. →  ssemble the wall mount screw on 2 left and 2 right location A on the top part and 1 left and 1 right location on the bottom part. →  t this time, use a "+" driver (Manual or motorized) or 8mm A wrench to tighten the screw so that the wall, wall bracket and screw are completely pressed against one another. <When mounting to wooden studs> 76mm drywall 406mm wood stud drywall a. Locate and mark the centers of the wall studs using a stud finder.  fter aligning the wall bracket on the wall where the center of the wood stud is marked, mark the location of the screws and A then remove the wall bracket. Use a level to make sure your screw marks are level. [. . . ] *C   aution : Prevent the power cord from being pinched between the wall mounting bracket and the set when installing the set. (A pinched power cord may cause an electrical short) ENGLISH Please follow the below direction. The display panel on Cinema Screen models (LM64**, LM66**, LM67**, LM76**, LM86**) can be easily damaged by pressure or shock. For more information, please refer to the owner's manual of the TV. 5 How to level the Display After installing the display, check to make sure it is level. [. . . ]