User manual LG LSW600B

[. . . ] Use of stud finder, a separate device, is recommended. * nstall the product only on a vertical wall. [. . . ] Set the wall mount on the wall by aligning to the location of the hole. and, set the angle adjusting part to face upward. Align the wall mount bolt to the hole and tighten it. Then, fasten the bolts at torque of 45 - 60 kgf/cm. 3 How to install the wall mount →  the screw cannot be assembled in the designated location inevitably, it can be assembled by rearranging to the If closest location. But, do not change 2 or more locations from the designated spot. → Fix the right and left side with two bolts each. → Wall mounting equipment will be set up based in VESA 600X400 regulation. →  t this time, use a "+" driver (Manual or motorized) or 8 mm wrench to tighten the screw so that the wall, wall A bracket and screw are completely pressed against one another. 5 ENGLISH How to attach to masonry walls 4 How to assemble the wall mount support and display - Always install the display with 2 or more people. Safety clip 1.  the display with the guide spacer assembled on the wall mount bracket on the wall in arrow direction. Set At this time, align the bottom assembly part and lift the set up lightly to align the top part.  When adjusting the horizontal level, use the safety ring provided by pressing it slightly to in the direction as illustrated. [. . . ] Do not forget to remove the bolts on both sides of P the set before adjusting the height. Anchor the bolts again after height adjustment. [. . . ]