User manual LG NB2020A

[. . . ] Safety way to remove the battery or the battery from the equipment: Remove the old battery or battery pack, follow the steps in reverse order than the assembly. To prevent contamination of the environment and bring on possible threat to human and animal health, the old battery or the battery put it in the appropriate container at designated collection points. Do not dispose of batteries or battery together with other waste. [. . . ] 5. For more detailed information about disposal of Your old batteries/ accumulators, please contact Your city office, waste disposal service or the shop where You purchased the product. LG Electronics hereby declares that this/ these product(s) is/are in compliance with the essential requirements and other relevant provisions of Directive 2004/108/ EC, 2006/95/EC and 2009/125/EC. European Standards Centre: Krijgsman1, 1186 DM Amstelveen The Netherlands yy Please note that this is NOT a Customer Service contact point. For Customer Service Information, see Warranty Card or contact the dealer that you purchased this product. NB2020A-N0. DDEULL_ENG_4451. indd 3 2012-07-06 10:20:51 4 Table of Contents Table of Contents 1 Getting Started 3 Operating 12 Operations 12 –  DOLBY DRC (Dynamic Range Control) 12 –  AV Sync 12 –  AUTO POWER DOWN 12 –  AUTO POWER On/Off 12 –  Turn off the sound temporarily 13 Controlling a TV with the Supplied Remote Control 2 Safety Information 6 Accessories 6 Introduction 6 –  Symbols Used in this Manual 7 Remote control 8 Front panel 8 Rear panel 9 Installing the sound bar 9 Installing the cover foot 2 Connecting 10 11 11 Mounting the main unit on a wall Optional Equipment Connection –  OPTICAL In connection NB2020A-N0. DDEULL_ENG_4451. indd 4 2012-07-06 10:20:51 Table of Contents 5 4 Troubleshooting 14 Troubleshooting 5 Appendix 15 Maintenance 15 –  Handling the Unit 16 Trademarks and Licenses 17 Specifications 1 2 3 4 5 NB2020A-N0. DDEULL_ENG_4451. indd 5 2012-07-06 10:20:51 6 Getting Started Accessories Please check and identify the supplied accessories. Introduction Symbols Used in this Manual Note , , Indicates special notes and operating features. 1 Getting Started Caution >> Remote control (1) Batteries (1) Indicates cautions for preventing possible damages from abuse. Wall Mount Bracket Installation Template (1) Wall bracket (2) Optical cable (1) Cover foot (2) NB2020A-N0. DDEULL_ENG_4451. indd 6 2012-07-06 10:20:52 Getting Started 7 Remote control • • • • • • • • • • a • • • • • • • • • • 1 (Power): Switches the unit ON or OFF. DOLBY DRC (ON/ OFF) : Sets the Dobly DRC. • • • • • • • • • • b • • • • • • • • • • : Mutes the sound. AV SYNC -/+ : Synchronizes the audio and video. 1 Getting Started yy When the volume reaches the highest/ lowest level and you push VOL+/- on the remote control again, red LED on the unit turns on for 2 seconds to signal on what the volume level is. yy When the unit turns on, volume of the unit will rise gradually to the volume level set at the unit turned off. Note , , • • • • • • • • • • c • • • • • • • • • • TV Control buttons: See page 13. AUTO POWER (ON/OFF) : This function is automatically turned on the unit. Battery Installation Remove the battery cover on the rear of the Remote Control, and insert (size AAA) battery with and matched correctly. NB2020A-N0. DDEULL_ENG_4451. indd 7 2012-07-06 10:20:52 8 Getting Started Front panel 1 Getting Started A 1 (Standby/On) B – / + (Volume) Adjusts speaker volume. Rear panel A S/W Download Connector - Only for service. B OPTICAL IN NB2020A-N0. DDEULL_ENG_4451. indd 8 2012-07-06 10:20:52 Getting Started 9 Installing the sound bar You can hear the sound by connecting the unit to the other device : TV, Blu-ray disc player, DVD player, etc. Place the unit in front of the TV and connect it to the device you want. (Refer to page11) Installing the cover foot You can extend the height of the unit. 1 Getting Started 1. Turn the unit upside down. 2. After detaching a release layer on the cover foot, Put it on the foot of the unit. 3. Make the cover foot attached firmly to the unit by pushing it strongly. NB2020A-N0. DDEULL_ENG_4451. indd 9 2012-07-06 10:20:53 10 Connecting 2. When you mount it on a wall (concrete), use the wall plugs (Not supplied). A guide sheet (Wall Mount Bracket Installation Template) is supplied to drill. [. . . ] Use AV SYNC -/+ to scroll up and down through the delay amount, which you can set at anything between 0 and 300m/sec. If you don’t connect external device to the unit by optical cable or there is no digital input, the unit is turned off after 15 minutes when you turn on this function. Note , , Turn off the sound temporarily Press to mute your unit. You can mute your unit, for example, to answer the telephone. When the AV SYNC reaches the highest/lowest level and you push AV SYNC -/+ on remote control again, red LED on the unit turns on for 2 seconds to signal on what the AV SYNC level is. Note , , Red LED on the unit blinks at intervals of 2 seconds to signal that the unit is in mute mode. Note , , AUTO POWER DOWN This unit turns off automatically to save power consumption if no signal is transmitted to the unit for about 25 minutes. But the unit can turns on automatically based on the [AUTO POWER] function you've set. NB2020A-N0. DDEULL_ENG_4451. indd 12 2012-07-06 10:20:54 Operating 13 Controlling a TV with the Supplied Remote Control You can control your TV using the buttons below. [. . . ]